COOSPO BC107 - Power Calibration; Initiating Power Calibration; Recalibrating Power Meter; Saving Calibration Results

- 14 -
Press
Save and get back (Automatically exit if
no operation detected in 20 seconds)
Recalibrate
1.1 Hold the to get into setting mode;
2.1 There are 5 settings pages available (P1 ~ P5), press the to switch to P5, it will automatically calibrate;
2.2 Short press to recalibrate, the value flashes during the calibration, the value does not flash after the
calibration is successful;
2.3 After the calibration is successful, press to save and exit(Automatically exit in 20 seconds if no
operation detected).
Power calibration