1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page Product fiche.
Make sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause
button, the dishwasher will start its cycle.
Changing The Program Mid-cycle
A program can only be changed if it has been running only for a short period of
time, otherwise the detergent may have already been released or the the wash
water with detergent has already been drained. If this is the case, the dishwasher
needs to be reset and the detergent dispenser must be refilled.
15
Program
Running
Time(min)
Energy
(kWh)
Water
(L)
Description
Of Cycle
Rinse
Aid
Detergent
Pre/Main Wash
Soak
Rapid
Wash(45℃)
Rinse
Rinse(45℃)
Prewash
18g
15
30
0.020
0.690
10.1
3.6
NOTE:
(*EN60436)
(1tab)
\
: The ECO program is suitable to clean normally soiled tableware, that
for this use, it is the most efficient program in terms of its combined
energy and water consumption, and it is used to assess compliance
with the EU ecodesign legislation.
Starting A program
Saving Energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption
and is not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and
water in the use phase than hand dishwashing when the household dishwasher is
used according to the instructions.
To Next Page
Loading...
