8. Percentage Drag Brake - 0 %( Default) 4%, 8%, 12%, 15%, 20%, 25%, 30%
The drag brake function provides the driver a set percentage of brake when you have the transmitter
resting in neutral. This will create the “feel” of a brushed motor.
Drag brake are used in racing to slow a vehicle as you let off approaching a corner versus the driver
having to push the brake at every corner.
Try working with this to get a sense of how you might use this for your track.
If you are running on a high traction track with tight corners, a stronger setting should work best.
If you are running in an open area, you will find a smaller percentage will result in better control.
If you are running in dusty or slippery surfaces, you will more than likely want to use the lowest option.
9. Motor Rotation
Normal (default), Reverse
10. Neutral Range – This setting adjusts the amount of “Deadband” of neutral on the throttle. This
is in Milli-Seconds (MS) and is the amount of neutral when you apply throttle.
The smaller the value the less “Deadband” or movement is required off-center for the PACE-45R to
begin throttle functions.
Using a higher value for this setting will provide a wider Deadband.
2%, 3%, 4% (Default), 5%, 6%, 10%
Using Program card
1. The Program card with LED display is easy to use and convenient to carry. All of the programmable
functions are shown on the program card.
2. Turn on the PACE-45R. Remove the Signal wire and plug it into the top right hand socket on the
Program card, wait for 2 seconds until the LED is ON.
The first programmable function will be shown, if an error occurs, please reconnect them.
3. If PACE-45R is not connected with the batteries, the Program card should be connected with other
power supply, the range of power supply is within 5.0-6.3V.
4. Press the button “Menu” on the Program card and circularly select each programmable function. At
that time the number of the programmable function will be displayed on the left of the LED, the
current value will be displayed on the right side. Then press the button Value to change the value and
press the button OK to confirm. At the same time the Red indicating LEDs of both program card and
the PACE-45R blink. Turn off the PACE-45R; the modified settings will be saved in the PACE-45R‟s
memory.
5. Press the button Reset to restore the default settings.
To Previous Page
Loading...
Need help?
General