Corghi Erco X5000 CT LT PT2 FAST

Questions and Answers

S
sanchezalyssaAug 8, 2025
Why does my Corghi Lifting Systems motor stop when lifting?
- T
  Tim HillAug 8, 2025
  If your Corghi Lifting Systems motor stops while ascending after repeated lifting cycles, this could be due to the thermal protection activating because the motor is overheating (ALARM 02). To resolve this, wait for a period of time to allow the motor to cool down.
M
Maurice CastroAug 12, 2025
How to troubleshoot a Corghi Lifting Systems with no power light?
- J
  Jordan BaxterAug 12, 2025
  If the main switch of your Corghi Lifting Systems is on, but the power light is off, there could be several reasons: * There might be no connection to the network socket. Check the power supply cable's connection to the network socket. * The transformer protection fuses or line fuses might have blown. Replace the burnt fuses. If they burn again, contact technical assistance. * There could be an electric transformer fault. In this case, contact technical assistance.
M
Michele ChurchAug 16, 2025
Why is my Corghi Erco X5000 CT LT PT2 FAST Lifting Systems motor so noisy?
- G
  grantrachelAug 16, 2025
  If your Corghi Lifting Systems motor is very noisy, the control unit vibrates greatly, and the lift isn't powered, it could be due to a missing electrical phase. This might be because of a burnt fuse, so replace the burnt fuse. If the motor remains noisy after replacing the fuse, contact technical assistance. Alternatively, a missing electrical phase could be due to clamp loosening, even if the fuses are intact. In this case, contact technical assistance for a check.
M
Michael JohnsonAug 21, 2025
What to do if Corghi Lifting Systems motor turns but lift doesn't go up?
- L
  Lawrence StokesAug 21, 2025
  If, when pushing the up button on your Corghi Lifting Systems, the motor turns but the lift doesn't go up, it could be due to an incorrect phase connection in the mains power plug, causing the motor to rotate in the opposite direction. Check the connection to the network socket and restore it if necessary. It may also indicate an electrical system anomaly, in which case you should contact technical assistance.
A
Arthur ParkAug 26, 2025
What to do if Corghi Erco X5000 CT LT PT2 FAST lift blocks during a manoeuvre?
- J
  jennifer95Aug 26, 2025
  If your Corghi Lifting Systems blocks during a manoeuvre, this could be due to a load imbalance, a fault in the hydraulic system, or an issue with the position transducers. To address this, put the load to the ground following the manual emergency procedure and contact technical assistance.
S
Scott BassAug 30, 2025
What to do if Corghi Erco X5000 CT LT PT2 FAST lift does not respond to controls?
- R
  ralphhillAug 30, 2025
  If the main switch is on, the power on light is on but the Corghi Lifting Systems lift does not respond to any control, it could be due to a fuse burning on the electronic board. Replace the burnt fuse on the electronic board; if the fuse burns again, contact technical assistance.
A
Alan Bryant Jr.Sep 3, 2025
Why does Corghi Lifting Systems ascent become irregular?
- H
  Howard RandallSep 3, 2025
  If the ascent of your Corghi Lifting Systems becomes irregular and uncoordinated after reaching a certain height, it's likely due to air intake in the hydraulic circuit caused by a low oil level. Add oil until it reaches the regular maximum level as specified in the operator's manual.