SEAT CAP INSTALLATION
14
SECURITY LABELS INSTALLATION
15
Install the four (4) safety labels (DANGER) supplied with your pool
as follows: two (2) labels visible at the entrance to the pool and two
(2) visible at the main access of the backyard.
Important: if you require additional labels, please contact us at
Corneliuspools.com
Install a minimum of three (3) safety labels (supplied with the liner)
inside the pool so that at least one label is visible no matter where
the bather enters the water (see drawing for positionning)
Straight section : Starting inside the pool, slide the seat cap on the
post until it hooks on the edge of the ledge.
Round section : Snap the seat cap starting outside the top seat.
Then snap the other side inside the top seat.
To Next Page
Loading...
