7
Hacking Detection
After 5 unsuccessful User/Admin PIN entry attempts, your Flash Padlock 3 will be disabled for 2 minutes. The red LED
will start blinking rapidly and continue doing so for 2 minutes to indicate the unit has been locked. User/Admin PIN
entry will not be allowed at this state. Also, keep in mind that clearing your User PIN with admin PIN (if set) in that 2
minute time window is also disabled.
After 2 minutes, you can attempt to unlock your Flash Padlock 3. After another 5 more unsuccessful User/Admin PIN
entries (now 10 total) the drive will be disabled for 12 hours. The red LED will start blinking rapidly for 30 seconds and
then your Flash Padlock 3 will enter sleep state. At that point pressing KEY button will again cause red LED to start
blinking rapidly for 30 seconds followed by entering sleep state to indicate the drive has been locked.
Any subsequent attempt to press KEY button will before 12 hours is elapsed will repeat above sequence.
After 12 hours, you can attempt to unlock your Flash Padlock 3. After another 5 more unsuccessful User/Admin PIN
entries (now 15 total) the drive will be disabled for 2 minutes. The red LED will start blinking rapidly and continue
doing so for 2 minutes to indicate the unit has been locked.
After 2 minutes, you can attempt to unlock your Flash Padlock 3. After another 5 more unsuccessful User/Admin PIN
entries (now 20 total) the User PIN and Admin PIN will be cleared. Your Flash Padlock 3 will now be unlocked and all
data will be permanently lost.
For More Information
Visit corsair.com and click on “support.”
© 2017 Corsair Components, Inc. All rights reserved. Corsair, the sails logo, and Flash Padlock 3 are registered trademarks in the United
States and/or other countries. All other trademarks are the property of their respective owners. Product may vary slightly from
those pictured. 49-001575 revAA
Flash Padlock is developed and produced by Corsair Components, Inc. based on the licensed DataLock
®
technology (patents pending)
from ClevX, LLC (clevx.com)
To Previous Page
Loading...
Need help?
General
