Need help?Do you have a question about the Corsair h60 and is the answer not in the manual?
General| Type | Liquid CPU Cooler |
|---|---|
| Radiator Size | 120mm |
| Fan Speed | 1700 RPM |
| Noise Level | 28.3 dBA |
| Radiator Material | Aluminum |
| Fan Dimensions | 120mm x 120mm x 25mm |
| Fan Airflow | 57.2 CFM |
| Warranty | 5 years |
| Compatibility | Intel 1366, 2011, 2066; AMD AM2, AM3, FM1, FM2, AM4 |
| Radiator Dimensions | 157 x 120 x 27 mm |
Lists all hardware components included for Intel installation.
Attach the radiator and fan, recommending air-intake for optimal cooling.
Install the Intel Backplate onto the motherboard; LGA 2011 does not require one.
Install standoff screws, using F for LGA 1155/1156 and G for LGA 2011.
Insert the mounting bracket onto the top of the pump as shown.
Align the bracket and pump over standoff screws and tighten thumb screws.
Connect the pump power connector to an available 3-pin or 4-pin fan header.
Lists all hardware components included for AMD installation.
Attach the radiator and fan, recommending air-intake for optimal cooling.
Insert the mounting bracket onto the top of the pump as shown.
Insert AMD screw clips and secure with screws, not fully tightening.
Align bracket with AMD mounting clips and tighten thumb screws until secure.
Connect the pump power connector to an available 3-pin or 4-pin fan header.
Answers common questions about fan airflow, thermal paste reuse, screw purchases, and radiator mounting.
To Next Page
