Corsair H100i v2 User Manual

Note: Most newer PC cases include a CPU cutout to allow access to the bottom
of the motherboard. If your case does not include a cutout, you will need to
remove your motherboard from the case before installation.
Included Hardware
Highlighted parts for Intel installation only
Note: The H100i v2 comes with Intel mounting bracket pre-installed on the pump for quick installation.
x1 INTEL MOUNTING BRACKET
(PRE-INSTALLED)
I
x8 SHORT SCREWS
K
CORSAIR LINK USB CABLE
(Included)
L
x2 SP120L FANS
F
x1 INTEL BACKPLATE
H
x8 LONG FAN SCREWS
A
x4 THUMBSCREWS
E
x4 LGA 2011 STANDOFF
C
x4 LGA 115X / 1366 STANDOFF
B
x16 WASHER
G
x4 AMD BLACK STANDOFF
D
x1 AMD MOUNTING
BRACKET
J
TM
QUICK START GUIDE
EXTREM
E PERFORMANCE LIQUID CPU COOLER
H100i v2

Corsair H100i v2 Specifications

General

Radiator Dimensions	276mm x 125mm x 30mm
Fan Dimensions	120mm x 25mm
Noise Level	37.7 dBA
Radiator Material	Aluminum
Fan Airflow	70.69 CFM
Radiator Size	240mm
Tube Length	300mm
Warranty	5 years
Fan Speed	2435 RPM
Compatibility	Intel LGA 1150, 1151, 1155, 1156, 1366, 2011, 2011-3, AMD AM2, AM3, FM1, FM2
Fan Static Pressure	4.65 mmH2O
Type	Liquid Cooling System
Tubing Material	Low-permeation rubber with black sleeving

Summary

INTEL Installation

Installing the Intel Backplate

Guide for properly attaching the Intel backplate to the motherboard for installation.

Installing the Intel Standoff Screws

Instructions for attaching the correct standoff screws for Intel LGA 115X/1366 or LGA 2011 sockets.

Install the Fans and Radiator

Steps for mounting the cooling fans and radiator unit onto the PC case.

Installing the Pump Unit

Procedure for aligning and securing the CPU cooler pump unit onto the motherboard standoffs.

Connect Power to the Fans and Pump

Details on connecting the pump and fan power cables to motherboard headers and pump.

Connect Pump to USB Header

Guide for connecting the pump unit to a motherboard USB header using the Corsair Link cable.

AMD Installation

Installing the AMD Standoff Screws

Steps to remove existing AMD brackets and attach the new standoff screws for AMD installation.

Installing the AMD Mounting Bracket

Instructions for removing the Intel bracket and installing the AMD retention bracket correctly.

Install the Fans and Radiator

Steps for mounting the cooling fans and radiator unit onto the PC case, similar to Intel.

Installing the Pump Unit

Procedure for aligning and securing the CPU cooler pump unit onto the AMD standoffs.

Connect Power to the Fans and Pump

Details on connecting the pump and fan power cables to motherboard headers and pump.

Connect Pump to USB Header

Guide for connecting the pump unit to a motherboard USB header using the Corsair Link cable.

FAQ