Frequently Asked Questions
10. Installing the Front I/O Connectors
9. Connecting the Fan Controller
1. Connect the SATA power
connector to the PSU SATA
power cable.
2. Connect the 3 or 4-Pin fan
connecter to the case fan
header.
3. Push the fan speed selector
button on your case to
toggle fan speed.
1. How do I remove the I/O Panel ?
If needed, you can uninstall your I/O panel by removing the front
fascia (step 5) then unscrewing the 2 screws at each side of
panel. (see drawing).
2. Does the polarity matter with the I/O panel’s power and
reset header?
No, only the LED headers.
3.
Where can I mount a fan?
Fan Mount Locations
Front 2 x 140mm or 120mm (2 x 120mm included)
To p 2 x 120mm
Rear 120mm (included)
Bottom 120mm
Side x
Mid x
1
2
3
See your motherboard’s
manual for front panel header
locations and pin-outs.
USB 3.0
HD AUDIO RESET SW
POWER LED +
POWER LED –POWER SW
HDD LED
To Previous Page
Loading...
