IMPORTANT SAFETY INFORMATION ABOUT PROPANE(LP) GAS
• The LP-gas supply cylinder to be used must be constructed and marked in accordance with the U.S.
Department of Transportation(DOT)Specifications for LP-Gas Cylinders, or the Standard for Cylinders, Spheres and
Tubs for Transportation of Dangerous Goods and Commission, CAN/CSA-B339,as applicable.
• The LP-gas supply cylinder to be used must have a listed overfilling prevention device(see Figure 1).
• The LP-gas supply cylinder to be used must have a cylinder connection device compatible with the
connection for the appliance.
• A self contained LP-gas cylinder for use with this appliance must have a capacity of 20 lbs. cylinder
(Height about 18 in, Tank Body about dia 12 in, Base about dia 8 in).
• The cylinder supply system must be arranged for vapor withdrawl.
• The cylinder used must include a collar to protect the cylinder valve.
• This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a building, garage
or any other enclosed space.
• When this appliance is not in use, the gas must be turned off at the supply cylinder.
•
Storage of this appliance indoors is permissible only if the cylinder is disconnected and removed from the Appliance.
• Cylinders must be stored outdoors in a well-ventilated area out of the reach of children. Disconnected cylinders
must have threaded valve plugs tightly installed and must not be stored in a building, garage or any other
enclosed areas.
• This appliance is certified by CSA(Canadian Standards Association) to ANSI Z21.97/CSA 2.41-2014 Outdoor
Decorative Gas Appliances.
• The gas hose is routed through two "U" rings to prevent the hose from coming in contact with the burner.
DO NOT remove the hose from the 'U' rings (See Figure 2).
3
Standard 20lb.tank
"U"ring
Figure 1
Figure 2
To Next Page
Loading...