EasyManua.ls Logo

Cosco 88-533DBTE - Operating Instructions; Lighting Instructions; Turning Off Gas; Care and Maintenance

Cosco 88-533DBTE
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and turn to "OFF" (see Figure 18).
2. Turn gas control knob to the " ".
3. Push in gas control knob all the way and hold. Continue to press the ignition button for 15 seconds.
4. If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5 minutes before
attempting to light the burner again, repeat step 1 to 3.
Observe Flame Height When Lit: Flame should be a blue/yellow color between 1-2 in. height.
TO TURN OFF GAS
Push in gas control knob slightly and turn to "OFF"
WARNING: For your safety, read and follow the Lighting Instructions in this manual and in the
Rating Plate on the appliance. IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR EXPLOSION
HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
CARE AND MAINTENANCE
To enjoy the outstanding performance from your fire pit, make sure you perform the following activities on
a regular basis:
1. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2. While cleaning the fire pit, make sure to keep the area around the burner dry at all times.
DO NOT submerge the control valve assembly. If the gas control is submerged in water,
DO NOT use it. It must be replaced.
3. Air flow must be unobstructed. keep controls, burner, and circulating air passageways clean.
Signs of possible blockage include:
(1) Gas odor with extreme yellow tipping of flame.
(2) Fire pit does NOT reach the desired temperature.
(3) Fire pit flame is excessively uneven.
(4) Fire pit makes popping noises.
(5) Spiders and insects can nest in burner or orifice. This dangerous condition can damage fire pit and render it
unsafe for use. Clean burner holes by using a heavy-duty pipe clearer. Compressed air may help clear away
small particles.
4. Carbon deposits may create a fire hazard. Clean burner with warm soapy water if any carbon deposits develop.
NOTE: Always allow fire pit to cool COMPLETELY before attempting service or maintenance.
Gas control knob
Ignition button
Figure 18
OFF
FERME
7