13
14
C. Basic Use
continued on next page.
C-2 Preparing Child Restraint to Fit
Your Child
Release Chest Clip
Press on chest clip release
button and pull apart.
Loosen Harness Straps
Push in on the harness
adjustment lever under the flap.
Pull out on harness straps just
above buckle tongues.
You
MUST make these adjustments with your child before
you install the child restraint in the vehicle.
Unbuckle Harness Straps
Press down on the red buckle
release button to release the
buckle tongues.
Place harness straps over sides
of child restraint.
3.
4.
5.
Place Child in Child
Restraint
Place the child’s bottom and
back flat against the child
restraint.
This will allow the harness
straps to be properly tightened.
6.
Pull UAS Belt Packaging Out
from the Shell
Remove UAS from any
packaging. Discard the
packaging.
1.
Secure UAS Belts
You
MUST attach the UAS hooks
to the UAS attachments as shown
when not in use.
2.
Check Buckle
Position
Determine which of the three
slots is closest to the child
and will provide a snug fit.
You MUST use the 1st
or 2nd buckle strap slots when rear facing.
Any slot can be used for forward facing.
1
2
3
7.
Rotate the metal retainer, then
insert retainer up through the
shell and pad.
a.
To Change Buckle Position
Remove child from child
restraint.
Turn the child restraint over
and locate buckle strap’s
metal retainer.
8.
4358-5974A CAN Scenera ENG.indd 15-164358-5974A CAN Scenera ENG.indd 15-16 10/23/14 8:57 AM10/23/14 8:57 AM
To Next Page
Loading...
