15
16
From the front, pull buckle strap
free from shell and pad.
b.
Insert the buckle’s metal
retainer through the desired
slot.
Make sure that the buckle is
facing out.
c.
Failure to place buckle strap’s metal
retainer completely through pad and shell
can result in serious injury or death.
Pull buckle’s metal retainer
completely through pad and
shell.
Pull up on buckle strap to make
sure it is secured.
The buckle must not pull out.
d.
e.
Check Harness Strap Height
With child in the child restraint,
check the location of the upper
harness slots.
Follow the guidelines on next
page to determine the correct
harness height.
9.
continued on next page.
Forward-Facing Position
Upper harness slots must be even
with or just above the shoulders.
If the highest upper harness slots
are below the child’s shoulders, do
not use this child restraint.
Rear-Facing Position
Upper harness slots must be
even with or just below the
shoulders.
If the upper harness slots are
above the child’s shoulders with
the headrest in the lowest position, do not use this child
restraint.
Children have a tendency to want to slouch.
Make sure the child’s bottom and back are flat against
the child restraint. If harness height is still incorrect, call
Consumer Relations for more detailed help.
To Change Harness Strap
Location
With harness system loosened,
from the back, unhook harness
strap loops from the splitter
plate.
From the front of child
restraint, pull harness straps
out of the upper harness slots.
a.
10.
C. Basic Use
4358-5974A CAN Scenera ENG.indd 17-184358-5974A CAN Scenera ENG.indd 17-18 10/23/14 8:57 AM10/23/14 8:57 AM
To Next Page
Loading...
