Pendular Spreader PDV-PDHV models
22
5.2. HOPPER LOAD
It is advised not to carry out the hopper loading manually but using a lifter or suitable mechanical
means.
ATTENTION!
The hopper must be loaded only after having hitched the spreader to the tractor.
During loading the Pto shaft must be disconnected, the tractor engine stopped, the control board key
must be removed and the parking brake put on.
Do not activate the pendulum when the exits are closed, because the fertilizer could be crushed
compromising the right machine working and causing breakings on the dosing system and on the
gear box.
During the hopper loading phase, if the machine needs to be lowered above the limit allowed by the
PTO shaft, disconnect it before lowering the machine further more.
Do not drive for very long distances with a full load and do not put full bags on the fertilizer loaded in
the hopper during the transport to the field or during the working, in order not to overload the
capacity of the machine and to compress the fertilizer.
WARNING!
During the operations of transport, stock and use of fertilizers, the operator must
be behaved in compliance with the indications on the label of the product and in
particular with the content of the sentences of risk and the precaution advices.
5.3. SPREADING OF THE FERTILIZER ON THE FIELD
ATTENTION! - WARNING!
The operator, during the period of use, maintenance, repair, transport or storing of the
machine, must wear accident-prevention shoes and gloves of security. If it is necessary, he will
have, moreover, to wear headset, mask and glasses.
After having connected the machine to the tractor and after the necessary
regulations, it is possible to begin to work.
The exits opening on the bottom of the hopper is made by operating on the
distribution lever, located on the front of the machine.
Do not connect the Pto shaft when the tractor is in the acceleration phase.
When using the power take-off lever of the tractor avoid any sudden and inappropriate movements;
hold the lever until the Pto shaft will begin turning and after that release the lever slowly.
Recommended working height: 75 cm.
To Next Page
Loading...
Need help?
General
