Cosmo PLS 500 User Manual

2
0
5.5. FULL WIDTH SPREADING
After having hitched the machine to the tractor and having carried out the necessary regulations, it is
possible to begin to work.
• Engage the axle with the pin, so that the spreader can be set in action by the turning wheels, only
• when the spreading operation has to be carried out.
• Various ways there are to spread the fertilizer in the field. One of the simplest methods is, as follows:
• Position the spreader at the beginning of the field you intend to fertilise, to a distance (D/2) that is the
half of the working width that is used (point 1);
• Drive in the field, distributing the fertilizer on all the perimeter;
• Stop the tractor at one distance (D) from the point 1, equivalent to the set working width (point 2);
• Begin the spreading proceeding in line, straight to point 3. Turn the tractor and drive a D distance,
equal to the working width (point 4);
• Repeat such procedure until all the plot will be covered.
ATTENTION! - WARNING!
The operator, during the period of use, maintenance, repair,
transport or storing of the machine, must wear accident-
prevention shoes and gloves of security. If it is necessary, he
will have, moreover, to wear headset, mask and glasses.
ATTENTION!
Before getting off the tractor and before any operation of
maintenance and regulation, set in action the parking brake, turn
off the engine, remove the ignition key from the dashboard and
await the stop of all the moving parts.

Cosmo PLS 500 Specifications

General

Brand	Cosmo
Model	PLS 500
Category	Spreader
Language	English