Installation
BEFO
RE USING YOUR ICE MAKER
• REMOVE THE EXTERIOR AND INTERIOR PACKAGING MATERIAL.
• CHECK TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS:
• 1 DOOR HANDLE& 2 SCREWS
• 2 DECORATIVE PLUGS
• 1 ICE BUCKET
• 1 ICE SCOOP
• 1 INSTRUCTION MANUAL (THE ONE YOU ARE READING)
• BEFORE CONNECTING THE ICE MAKER TO THE POWER SOURCE, LET IT STAND UPRIGHT FOR
APPROXIMATELY 4 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A MALFUNCTION IN THE
COOLING SYSTEM FROM HANDLING DURING TRANSPORTATION.
• CLEAN THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.
INSTALLATION THE ICE MAKER
• THIS APPLIANCE IS DESIGNED TO VENT HOT AIR THROUGH THE FRONT VENT. THIS ALLOWS FOR
INSTALLATION IN A RECESSED OR BUILT-IN APPLICATION, IF DESIRED.
• PLA
CE YOUR ICE MAKER ON A LEVEL SURFACE THAT IS
STRONG ENOUGH TO SUPPORT THE ICE MAKER WHEN IT IS
FULLY LOADED. REMEMBER THAT THE UNIT WILL BE
SIGNIFICANTLY HEAVIER ONCE IT IS OPERATIONAL AND
FULLY LOADED. LEVEL YOUR ICE MAKER BY ADJUSTING THE
LEGS AT THE FRONT OF THE ICE MAKER.
• LOCA
TE THE ICE MAKER AWAY FROM DIRECT SUNLIGHT
AND SOURCES OF HEAT (STOVE, HEATER, RADIATOR, ETC.).
DIRECT SUNLIGHT MAY AFFECT THE FINISH AND HEAT
SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREME COLD AMBIENT TEMPERATURES
MAY ALSO CAUSE THE ICE MAKER MALFUNCTION. THIS ICE MAKER IS DESIGNED FOR
INSTALLATION INDOORS IN “ROOM TEMPERATURE” AMBIENT CONDITIONS.
• POSITION UNIT TO ALLOW FREE AIRFLOW THROUGH
THE FRONT GRILLE , AVOID LOCATING THE ICE
MAKER IN MOIST/HUMID AREAS. TOO MUCH
MOISTURE IN THE AIR WILL CAUSE FROST TO FORM
QUICKLY ON THE EVAPORATOR REQUIRING
FREQUENT DEFROSTING.
• PLUG THE ICE MAKER INTO AN EXCLUSIVE
PROPERLY INSTALLED GROUNDED WALL OUTLET. DO NOT UNDER ANY CIRCUMSTANCES CUT OR
5
To Next Page
Loading...