REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD. ANY QUESTIONS CONCERNING
POWER AND/OR GROUNDING SHOULD BE DIRECTED TOWARD A CERTIFIED ELECTRICIAN.
•
The product is designed and
manufactured for seamless integration
in the specified cutout opening shown,
which requires precise measurements.
The opening must be square and
plumb front to back. Although not
required, you may choose to increase
the overall cutout width for ease of
installation.
REVERSING THE DOOR SWING
THIS APPLIANCE HAS THE CAPABILITY OF THE DOOR OPENING FROM EITHER THE LEFT OR RIGHT
SIDE. THE UNIT IS DELIVERED TO YOU WITH THE DOOR OPENING FROM THE LEFT SIDE (HINGED ON
THE RIGHT).
Tools needed: flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, Make sure the ice maker is unplugged.
1. Open the screw cap on the top hinge and unscrew 3 bolts to take away the top hinge and then lift out the
door.
2. Peel off the door gasket, located the door handle mounting screw behind the gasket and unscrew to take
out the door handle, use the spare plugs in the accerssaies to cover the mounting hole.
D
H
W
We recommend to leave at least 2"for back,¼"ro top and sides.
6
To Next Page
Loading...