20
功能介绍
(2) Press and hold the [Emergency Call] Button to enter alarm mode.
(3) When emergency call is trigger, red LED indicator and alarm is on,
voice transmit is allowed after alarm is stop. When LED indicator
turns to orange fast ash, voice can be received at this time. The
number of remaining call cycles can be set through programming
software. The alarm will automatically exit after the remaining call
cycles is 0, or press the preset [Emergency Call] key to exit.
NOTE: It is not necessary to press and hold [PTT] button to make
emergency call. The radio will automatically activate the emergency
microphone, and you can speak to the microphone and send your
voice to the receiver.
Call Prompt (private call only)
1. Congure one touch call through programming software for private
call contacts.
2. After write to programmable key, press the program key to trigger
the call prompt.
3. After the transmitter triggers the call prompt, the receiver's LED
indicator will ashing red.
One Touch Call(private call only)
1. Congure one touch call through programming software.
2. After write to programmable key, press the program key to trigger
the one touch call.
3. The transmitter's red indicator stays on for a few seconds, and then
press the [PTT] key to transmit.
4. The receiver's green indicator stays on for a few seconds, and then
it can receive normally.
Features
功能介绍
Features
To Next Page