5
INSTALL TENSION BRACKET AND FIXINGS
1
CONNECT TENSION ROD TO MECHANISM
2
SET BRACKET HANDLE TO HORIZONTAL
fig. B
Page 29
Cutter Deck Installation (Tension Rod)
Installation (Fig. 38)
The Deck Tension Rod stabilizes the deck and applies
tension to the drive belt. The belt will not drive the
deck efficiently without this rod correctly installed. The
information in this section expands on the instructions
mentioned in the basic removal section.
IMPORTANT! DO NOT ATTEMPT TO INSTALL THE
DECK TENSION ROD UNLESS RUE CLIPS AND PINS
ARE FIRST INSTALLED ON BOTH FRONT AND REAR
DECK BRACKETS (fig. 50, 53 & 53a).
Three Deck Tension Rods are available. These rods
are specific to certain decks. The rod is supplied with
the deck as standard on models made after June
2014. The rods are also also available as a kit.
Select the required rod assembly then follow the
diagramatic guide outlined in fig. B - K. Ensure the
rod length is set according to the Fig. A
Kit Kit Number Compable Decks
Tension Rod Kit 1 50100041 36 HGM, 48 IBS
Tension Rod Kit 2 50100043 36 & 42 XRD
Tension Rod Kit 3 50100044
38 XRD, 36 & 42 IBS, 38 COMBI
Tension Rod Kit 4 50100053 48 XRD
Tension Rod Kit 5 50100052 44 COMBI
Tension Rod Kit 6 50100054 38 IBS
SET LENGTH
TENSION ROD DIAGRAM
Deck Rod Type Set Length (+/-5mm)
36 HGM ROD 1 205 mm
36 XRD ROD 2 250 mm
38 XRD ROD 3 275 mm
42 XRD ROD 2 245 mm
48 XRD ROD 4 175 - 180 mm
36 IBS ROD 3 280 mm
38 IBS ROD 6 300 mm
42 IBS ROD 3 280 mm
48 IBS ROD 1 205 mm
38 COMBI ROD 3 280 mm
44 COMBI ROD 5 230 mm
fig. A
fig. C
To Next Page
Loading...
Need help?
General
