CountyLine 17306 - OPERATION SAFETY RULES; MAINTENANCE AND STORAGE

Operator’s Manual
17306 CRT Tiller
6 For additional information email info@ardisam.com or call 800-345-6007 M-F 8-5
OPERATION SAFETY RULES
 
place.
 
in the free-wheel position. Make sure the wheel lock pins
are engaged through the wheel hubs and wheel axle. The
wheels act as a brake to keep the tiller at a controlled speed.
Disengage wheel lock pins to permit free-wheeling only when
engine is stopped.
 
clear of tiller tines at all times.
 
pulled toward the handle bar (FORWARD position). Releasing
the drive safety control lever to the NEUTRAL position stops
the wheels and tines. If the unit does not stop when the lever
is in the NEUTRAL position an adjustment of the drive control
linkage, the belt alignment or the belt guides is required.
 
drives, walks or roads. Stay alert for hidden hazards or trac.
 
wire from the spark plug, thoroughly inspect the tiller for
any damage and repair the damage before restarting and
operating the tiller.
   STOP THE ENGINE AND
DISCONNECT THE SPARK PLUG WIRE before removing
vegetation by hand.
   
with bare skin or a severe burn may result.
 
and check immediately for the cause. Vibration is generally a
warning of trouble.
 
 
too deep at too fast a rate.
 
   
manufacturer of the tiller.
 
 
the ground and propel the tiller backward. If this occurs, let
go of the handle bars and do not restrain the machine.
   
unattended. Disengage all control levers, stop the engine,
wait for all moving parts to stop and make certain guards and
shields are in place.
 
- shut o the engine.
- wait for all moving parts to stop.
MAINTENANCE AND STORAGE
 
condition.
  
at frequent intervals for proper tightness to be sure the
equipment is in safe working condition.
 
the spark plug wire from the spark plug before performing
tiller maintenance.
 
 
 
closed building where fumes may reach an open ame or
spark. Allow the engine to cool before storing in any building.
 
details if the tiller is to be stored for an extended period.
 
prevent fuel from gumming up during an extended storage
period.
 
to protect against water and sunlight has been proven to
minimize maintenance costs and prolong the life of the
machine.
L
R
IMPORTANT
THE RIGHT AND LEFT SIDES OF YOUR
ROTOTILLER ARE DETERMINED FROM
THE OPERATING POSITION AS YOU FACE
THE DIRECTION OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY
WITHOUT OIL. YOU MUST ADD ENGINE
OIL BEFORE STARTING ENGINE.
IMPORTANT
NEVER START THE ENGINE OR OPERATE THE TILLER
WITH THE WHEELS IN THE FREEWHEEL POSITION.
MAKE SURE THE WHEEL LOCK PINS ARE ENGAGED
THROUGH THE WHEEL HUBS AND WHEEL AXLE. THE
WHEELS ACT AS A BRAKE TO KEEP THE TILLER AT A
CONTROLLED SPEED. DISENGAGE WHEEL LOCK PINS
TO PERMIT FREEWHEELING ONLY WHEN ENGINE IS
STOPPED.