10
Two fittings located underneath the spreader, and two on
each side of the agitator outside of the hopper.
2. After every use spray out hopper and spreading
drum. This will keep debris and manure from clogging
spreading drum and damaging the spreader
3. Check rubber guard after every use, replace as needed.
STORAGE
1. Before placing spreader in storage, make sure the
spreading drum and hopper have been cleaned of any
debris or manure.
2. The spreader can be stored either standing up against a
wall.
(continued from previous page)
3. Spreader can also be stored by leaning it back on
hopper.
TROUBLESHOOTING
If the manure spreader is not functioning properly check the
following.
1. Optimal speed is being met.
2. The levers on one or both wheels have been engaged.
3. There is no large debris lodged in the drum.
To Next Page
Loading...