CountyLine MS10 - OPERATION & MAINTENANCE; Attaching, Operating, and Detaching; Routine Maintenance

To Next Page

To Previous Page

OPERATION & MAINTENANCE

ATTACHING

1. First make sure you’re on a level surface. Back atv/utv

up to the tongue of the spreader. Align holes on the

hitch and tongue of spreader.

2. Once holes are aligned, drop in the hitch pin.

3. After the hitch pin has been successfully placed through

the hitch and tongue, then install cotter pin.

OPERATION

1. To begin operating the manure spreader, ﬁrst ﬁll

spreader with manure.

2. The ﬂip lever to engage spreading drum.

Lever not engaged

Lever engaged

DETACHING

1. Unengaged lever on wheels so the spreading drum

doesn’t turn.

2. Remove cotter pin, and then remove hitch pen. Manure

Spreader is detached from atv/utv and ready to be

cleaned.

MAINTENANCE

1. Before every use grease all four grease ﬁttings.

NOTE: If you will be making a large number of turns

while spreading engage only one wheel. Engage

the wheel opposite of the way you will be turning.

For example, if you’re turning right engage the left

wheel. For straight line spreading or heavy loads,

engage both wheels. Optimal speed for best results

are between 10-16 mph.