What to do if my Covaris S Series shows no power?
If your Covaris Laboratory Equipment isn't powering on, first ensure the line cord is properly connected. If it is, check and replace the fuse S1/S2 in the line entry module. Also, check the Green LED2 on tuning board S220 and Green D1 on the Controller Board.
Why is my Covaris S Series ineffective and making a loud buzzing noise?
Ineffective treatment and buzzing from your Covaris Laboratory Equipment can occur if the bath temperature is too high, the bath is contaminated, not sufficiently degassed, or there is insufficient acoustic power. Verify chiller operation. Clean the bath, change the water, and degas it, checking the oxygen level with a DO meter. Run an acoustic power test.
What to do if my Covaris S Series Laboratory Equipment displays a Water Level Error?
A water level error on your Covaris Laboratory Equipment may be due to insufficient bath water, a contaminated level sensor, ambient light hitting the sensor, or a faulty sensor. Fill the bath to the indicator line, clean the bath and level sensor, shield the sensor from stray light, and if necessary, replace the sensor.
What to do if my Covaris Laboratory Equipment shows a Communication Error?
A communication error with your Covaris Laboratory Equipment can stem from corrupted USB drivers, incorrect tuning board switch settings, a defective USB cable, or using a USB cable that is too long. Reload the drivers, verify the correct switch settings, replace the USB cable, and ensure it does not exceed 2 meters in length.
How to fix Safety Interlock Error on Covaris S Series Laboratory Equipment?
To resolve a Safety Interlock Error on your Covaris Laboratory Equipment, verify the bath position and ensure that the lid of the acoustic bracket is fully down.
Why are there excessive degassing bubbles in my Covaris S Series?
Excessive degassing bubbles in your Covaris Laboratory Equipment may be caused by the inlet tube not being properly seated or a leak in the degas pump tubing or fitting. Make sure the inlet tube is inserted past the O-ring and check the integrity of the tubing and connections.
What to do if my Covaris Laboratory Equipment has no degassing bubbles?
If your Covaris Laboratory Equipment is producing no degassing bubbles, the degas inlet nozzle might be clogged, the degas pump may not be running, or the motor could be decoupled from the pump. Try cleaning the bath and degas pickup tube. Verify the water level and pump operation. Stop and restart the degassing pump.
Essential safety precautions for personnel operating the instrument.
Guidelines to prevent damage to the Covaris instrument during operation.
General safety guidelines for operating the Covaris S-Series instruments.
Explanation of the transducer's function and role in acoustic processing.
Details on the system's degas pump and its function for acoustic processing.
Daily checks and procedures for maintaining the instrument's performance.
Guide to identifying and resolving common instrument problems and symptoms.
Step-by-step instructions for performing various repair procedures on the instrument.
Procedures for diagnosing and replacing PCBs specific to the S220 models.
Procedure for measuring acoustic power output on S1/S2 models.
Procedure for measuring acoustic power output on S220 models.
Procedure for installing SonoLab software and USB drivers on Windows XP.
Procedure for installing SonoLab software and USB drivers on Windows XP or 7.
Wiring diagram for S1 and S2 Series instruments.
Wiring diagram for S220 Series instruments.
General| Brand | Covaris |
|---|---|
| Model | S Series |
| Category | Laboratory Equipment |
| Language | English |
To Next Page