SET UP SCREENS
Set Clock
On this screen you will set up date and time for your unit. Select set, then change the date and time using the arrow
keys. Once you have the current date and time set, click OK, and it will take you back to the menu screen.
Mode
On this screen you will find two camera modes, Photo and Dual. Select your desired mode using the arrow keys. When
your desired camera mode is highlighted, click OK, and the mode will be set.
• In Photo mode – the camera will only take images.
• In Dual mode – the camera will take both images and videos.
Screens you will see in each mode
In Photo Mode: All Screens in their listed order.
In Dual Mode: All Screens in their listed order.
Image Resolution
Here you will be able to select your desired megapixel rating. You have three options for megapixel rating 2, 4, and 20.
Use the arrow keys to select your desired setting and press OK. You will only be able to request HQ photos from the app
when image resolution is set to either 2MP or 4MP.
Capture Numbers
On this screen you can select the number of burst photos you would like to be taken each time the camera is triggered.
You can select 1-3 photos per trigger. Use the arrow keys to scroll through the list, and when your desired burst setting
is selected, click OK.
Video Resolution
Options here are 720p and 1080p. You’re WC20 will not transmit video, but videos can be taken and stored to your SD
card. If you would like videos taken, make sure your camera is set to “Dual” mode.
Video Length
You can set between :05-:60 videos.
Camera Name
You can set up to a 12-character name for your camera.
PIR Interval
PIR (Passive InfraRed) interval can be set between 1:00 – 60:00. Your PIR delay is adjusted in 1-minute intervals. This
controls how often a picture is taken if continuous motion is detected.
PIR Sensitivity
Adjust the sensitivity of your PIR sensor. Four options: Low, Normal, High, Auto.
Low: The camera will only trigger from major movements
Normal: The camera will trigger at a normal rate.
High: The camera will take pictures whenever movement is detected.
Auto: The camera will dynamically change the sensitivity based on the temperature around the unit.
To Next Page
Loading...
