CLEANING METHOD
■ Cleaning the pre-lter (every 2 ~ 4 weeks)
1. Open the front cover by pulling out
the end part above the air inlet.
2. Take out the pre-lter by pulling out on the handles.
∗
To prevent dust from falling o, remove the lter carefully without exerting a shock.
3. Clean the pre-ler with a vacuum cleaner or with water depending
on the level of contamination.
∗
When retting the pre-lter to the product, t it in the hook correctly.
4. Install the pre-lter after removing the moisture completely.
Fit the front cover back to the product.
Tips
- Always unplug the product before cleaning the lter.
- The pre-lter is reusable by removing dust or cleaning it with water.
- If the pre-lter is not cleaned for a long time, the product performance may deteriorate.
- The HEPA lter are not reusable with cleaning. Never clean them with water.
To Next Page
Loading...
Need help?
General
