13
14
HOW TO OPERATE
Check out water comes out from the hot and cold faucet before
turning on the hot and cold water switch to prevent malfunction
of heater and compressor.
WARNING
How to Drink Cold Water
After installed, moved, and severely shaken, about 30minutes are needed for
stabilization of cooling device and heating device before using the product.
Note
Step1
Step2
Push the cold water cup-touch
lever to extract the cold water.
Turn on the cold water switch on
the front and make sure that the
indicator of cold water is turned
on.
Preparation before Use
Step1
Step2
Turn on the cold and hot water
switch after 30 minutes from initial
installation.
Connect it to voltage rating that
matches it on the rating plate.
Then, open main water feed valve
to supply water to the filtration
system.
To Next Page
Loading...
