COX Contour - Page 124

122
DVR Network
DVR Network allows you to manage settings
related to your Whole Home DVR service. These
settings include: changing receiver names, viewing
DVR network, and changing network status of
DVRs.
Change Receiver Name
Change Receiver Name allows you to provide a
name for your receiver. This setting is extremely
useful when you subscribe to multiple DVRs for
your Whole Home DVR service. It allows you to
name DVRs so that you can identify them later
while scheduling recordings or while browsing
through recorded programs.
To Change Receiver Name, begin at the
ReceiversMenu:
1. Press the RIGHT arrow or SELECT
buttonto openthe Receivers Menu in
thecentercard.
2. Use the DOWN arrow to highlight DVR
Network and press SELECT or RIGHT arrow.
A DVR Network Menu will display in the
center card. With highlight on Change
Receiver Name, press SELECT to open up
the Change Receiver Name dialog box.
3. Using the UP/DOWN/LEFT/RIGHT/SELECT
buttons on your remote, enter a suitable
name for your DVR.
4. When the name is entered, press the
Bbutton to save this new name.
A Note About Change ReceiverName
You must complete this process separately on each
receiver in your household. If you do not change
receiver names, then DVRs will be identified using
names such as DVR 1, DVR 2, DVR 3 etc. and
non-DVR receivers will be identified as
Receiver 1, Receiver 2, Receiver 3 etc.
Highlight Receivers and then press SELECT to move
thehighlight bar to the options list in the center card.
PressingRIGHT arrow or SELECT will display options
pertaining to DVR Network.
Pressing SELECT on Change Receiver Name
allows you to provide a name for your receiver.
Press UP/DOWN/LEFT/RIGHT/SELECT buttons to
provide a name for the receiver.