PROGRAMMING TV/VCR COMBO CONTROL
(continued)
5. If you’ve located a TV/VCR setup code that
works your TV/VCR Combo and a separate TV
code is also listed, you’ll need to program this
code into the remote control to access volume
control (see Programming Device Control on
page 8).
If there is no separate TV code listed, you will
need to perform the following steps to access
volume control:
a. Press and hold SETUP until the VCR key
blinks twice, then release SETUP.
b. Enter 9 - 9 - 3.The VCR key will blink twice.
c. Press VCR once. The VCR key will blink
twice.
6. For future reference, write down each working
device code in the boxes below:
TV/VCR
TV (if used)
10
To Next Page
Loading...
