COX XR11 User Manual

This equipment has been tested and found to comply with
the limits f or a Class B digit al device, pur suant to part 15
of the FCC rule s. These limit s are designe d to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radi ate radio freq uency energ y and, if not used
in accordance with the instructi ons, may cause ha rmful
interfe rence to radio communications.
There is guar antee that inte rference w ill not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, the user is
encouraged to try to correct the interference by one or more
of the following measures:
 • Reor ientorrelo catetherecei vingantenn a.
 • Incr easeordecre asethesepa rationbet weenthe
equipment and receiver.
 • Connectt heequipmen tintoanoutleto nacircuit
dierent f rom that which t he receiver is co nnected.
 • Consultthedealeroranexperiencedremotecontrol
/TV tech nician for help .
 • Itiss tronglyrec ommendedth attheTVbepl ugged
into a separa te wall outle t.
The user is cautioned that changes and modications made
to this equipment without the approval of the manufacturer
could void th e user’s auth ority to ope rate this equip ment.
This device complies with part 15 of the FCC rules. Operation
is subject to t he following t wo condition s: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
“Caution”:ExposuretoRadioFrequencyRadiation.Antenna
shall be mounted in such a manner to minimize the potential
for human contact during operation to avoid the possibility of
exceedingt heFCCradiofr equencyex posurelimi t.
RadioExp osureStatem ent:Thisequ ipmentcompli eswith
theFCCradiat ionexposur elimitssetf orthforde vices
operating in an uncontrolled environment. This equipment
should be op erated with a mi nimum distance o f 2 cm
between t he radiator and f ront of face. T his equipment
should not b e placed direc tly on the ear wh en the speaker
is active .
FCC Compliance Statement
1 MeetYourRemote 2 TurnOnYourRemote 3 PairYourRemoteforVoiceControl 4 Control Your TV’s Power and Volume 5 Test Voice Control
Mic / Status LED
All Power
Voice Control
Push and hol d to talk.
Discover content by
channel, pr ogram or key
words.
Number Keys
Usepredici tvetext( T9)to
quickly se arch for content .
TV Input
Changestoth enext
available i nput on your T V
(ifprogr ammedinStep4)
TV Power
CONTOUR / Menu
AccessGuide ,Saved,
VideoOnDEMA ND,Apps,
SearchandS ettings .
Setup
Programre moteforAim
Anywhe reortocontrolyo ur
TV or audio d evice.
Press and hold t he Setup button (about 3
seconds) until the Sta tusLED changes from red
to green.
Press the CONTOUR button .
Follow the on-s creen instructio ns to enter the
3-digit co de that appears.
Once the code is corr ectly entered, your
CONTOURRemoteispaire dwiththedevice .
A
B
C
Use voice control to search for network s and shows, set DVR recordings,
and get recommendations. See Step 5 of this guide f or examples.
Using the list on th e right, nd the rst 5-
digit code for your TV manu facturer.
Press and hold t he Setup button (about 3
seconds) until the Sta tusLED changes
from red to green.
Enter the rst 5-dig it code for your TV
manufac turer.TheStatusL EDshouldash
green twice.
Verify that t he code was accepted by using
your remote to adjus t volume and turn the
TV on and o.
A
B
C
D
Press and hold t he Voice button until you
hear the audio tone .
Speak a voice comm and to the remote
while continuing to h old down the button .
Try one of the sugges tions to the left. T he
StatusLEDwillbeso lid blue while you
speak your comman d.
ReleasetheVoice button when you r
commandiscomplete .LookattheTVf or
the results of y our voice command.
A
B
C
Once your remote is paired with your set-top box, yo u can use voice control.
Not working? Make sure you’r e pressing the
Voice butto n while you spea k into the remote ,
and releas e it when comple te.
Pick up your remote an d remove the “Pull” tab
(on back) by pulling away from the rem ote. The
StatusLEDwillbl ink green four times as th e
remote powers u p (about 5 seconds).
Turn on your TV.
Turn on your set-top box.
A
B
C
Your remote arrives with the AA bat teries already installed, but not
activated. Here is ho w to power it on for the rst time.
Not working? Make sure the battery tab from
your remote is removed, your TV is on and you are
entering the correct 3-digit code on your TV screen.
Back
WATCH CNBC
FIND The Voice
SHOW ME all Eagles games
SHOW ME all kids m ovies on HBO
RECORD TheBiggestLo ser
KIDSZONE
GUIDE
WHAT SHOULD I WATCH?
WHAT’S ON NOW?
VoiceRemote
Start
If your code isn’ t listed or you would
like to control an audio d evice, visit
remotes.cox .com.
Popular TV Manufacturer Codes
LG 101 78, 1126 5
Panasonic 10051, 10250
Samsung 10812, 10 060
Sanyo 1015 4, 1015 9
Sony 10000, 11100
Sharp 10093,10165
Toshiba 101 56, 11156
Vizio 1175 8, 1175 6
Not working? Try the second code listed. Still
not working? Visit remotes.cox.com for a complete
list of codes.
Have an Audio Re ceiver or Soun d Bar? If you
would like to setup your remote to control your
audio device or sound bar, visit remotes.cox.com.
®
xr11_GSG_152mm_Aug.indd 1 8/4/15 11:30 AM

COX XR11 Specifications

General

Type	Remote Control
Brand	COX
Model	XR11
Category	Remote Control
Voice Control	Yes
Batteries	2 x AA
Backlit Buttons	No
Number of Supported Devices	1
Connectivity	Infrared (IR) and Radio Frequency (RF)
Infrared Range	30 feet
Power	Battery Powered