26
CHANGING VOLUME LOCK
The Cox Universal Remote Control is set to control volume
of a device through your TV while in the TV,VCR, or Cable
mode. However, in the Auxiliary mode, you will still have
separate control of of your auxiliary device’s volume.
If your TV is not remote controllable, or if you would like
the volume to be controlled by a different device, you can
change the Volume Lock setting to control a volume
through a non-associated mode (e.g., through the cable in
the TV mode).
To change Volume Lock to CABLE mode:
1. On the remote control, press CABLE once.
Then press and hold SETUP until the
CABLE key blinks twice, then release SETUP.
2. Enter 9 - 9 - 3.The CABLE key will blink twice.
3. Press CABLE once. It will blink twice.
4. Now, whenever you press VOL+, VOL-,or
MUTE, volume will be controlled by your
Cable Converter.
To change Volume Lock to TV mode:
1. On the remote control, press TV once.
Then press and hold SETUP until the TV key
blinks twice, then release SETUP.
2. Enter 9 - 9 - 3.The TV key will blink twice.
3. Press TV once. It will blink twice.
4. Now, whenever you press VOL+, VOL-,or
MUTE, volume will be controlled by your TV.
To change Volume Lock to VCR mode:
1. On the remote control, press VCR once.
Then press and hold SETUP until the VCR key
blinks twice, then release SETUP.
2. Enter 9 - 9 - 3.The VCR key will blink twice.
To Next Page
Loading...
