Cozy N Safe Apollo - Installation in the Vehicle (Group 0+); Installing the Child Seat (Group 0+)

9
5. INSTALLATION IN THE VEHICLE / GROUP 0+
4
2 3
5.1 INSTALLING THE CHILD SEAT
ONLY GROUP 0+
From Birth to 13kg (9 months to 13kg approx.)
1. Connect the seat to the 0+ base by inserng it into the holes
on the top of the child seat base. (fig.1)
2. Recline the child seat fully. Pull the seat recline lever upwards.
Recline the seat while keeping hold of the lever.
Release the lever when the seat is in the most reclined posion.
(fig.2)
3. Place the child seat in the rear of the vehicle, facing away from
the direcon of travel. (fig.3)
4. Turn unlock the sha and pull it out. (fig.4)
1
10
5. INSTALLATION IN THE VEHICLE / GROUP 0+
5. Pull away the seat shell away from the seat base, insert
3-point seatbelt through seat shell and seat base.(fig.5)
6. Abdomen part of the 3-point seatbelt go through two below
belt guiders, lock 3-point seatbelt unl you hear a “click”.
Then shoulder part of 3-point seatbelt go through one upper
belt guider which is close the retractor. (fig.6)
7. Push together the seat shell and seat base, insert back and
turn locked the sha. Pulling the 3-point seatbelt to remove
any slack, and make sure there is no twist. (fig.7)
5
7
6