58 CP Tech GmbH
11.2.3 Batteries
The batteries in the toe or leveling laser may
have to be replaced in between
maintenance intervals, depending on how
long the system has been in use. For the toe
laser, you must remove the four screws of
the cover plate on the underside and remove
the plate. The battery compartment can then
be removed. After removing the screw plug,
the two „AA” batteries can be replaced. Pay
attention to the correct polarity! Please make
sure that no cables are crushed or damaged
when assembling the toe measuring
module. The „Huepar 901CG” leveling laser
also works with four „AA” batteries. To replace them, you can simply open the battery
compartment on the underside of the leveling laser. Pay attention to the correct polarity of
the batteries!
11.2.4 Special service intervals
11.2.4.1 Electrical equipment
Fatal injury hazard due to electric shock
Touching live parts may result in a fatal electric shock.
– Only electrical specialists are allowed to work on the electrical equipment.
– Always shut off the power of the machine before maintenance and
inspection work.
• Perform a safety check in accordance with the country-specific guidelines and
standards.
11.2.5 Service of third-party components
For further information on service work on third-party components (laser, netbook,
charger), please refer to the documentation provided by the respective supplier.
To Next Page
Loading...