CP Electronics Vitesse Plus User Manual

Vitesse Plus Quick Start
Connect all detectors and switches to the LCM before following this procedure. Refer to the VITP7-MB installation guide
for details on how to do this.
CH1
CH5
CH2
CH3
CH6
CH7
CH1 CH2 CH3 CH4 CH5
CH6
CH7
CH6
Mains power supply
Master switch
Emergency
lighting
test
CH4

CP Electronics Vitesse Plus Specifications

General

Category	Control Systems
Frequency	50Hz
Protection Rating	IP20
Relative Humidity	95% non-condensing
Standards	EN 60669-2-1

Summary

Vitesse Plus Quick Start

Connect Power and Power Up Handset

Connect power to LCM and turn on the programming handset.

Navigate Vitesse Plus Menu

Select Vitesse Plus from PRODUCT FAMILY, then select LCM.

Configure Preset

Select Program, then Preset, and enter the preset number.

Send Command and Confirm

Point handset at device, press SEND, and return to Vitesse Plus menu.

Detector and Program Configuration

Select Detector and Program options for device settings.

Set Time Out and Light Level

Set Time Out (mins) and target lux value for daylight linking.

Activate Daylight Linking

Perform a specific switch sequence to activate daylight linking.