CPG G15 - CONVERSION (Manual Control); Natural Gas to Propane Conversion Procedure

5
CONVERSION (Manual Control)
These instructions are for the conversion from Natural Gas to Propane (L.P.) on all models. The
conversion should be done before connecting the unit to the gas supply.
Units are shipped from the factory equipped for use on natural gas. Orifices necessary for LP
(propane) are provided in a bag tied to the valve on the front panel.
1. Remove the knobs and front panel.
2 . Uns
2. Unscrew bolts and pilot valve,
then remove the manifold.
1.
Remove the knobs and front
panel.
Note: Unit Number on side
of orifice fittings.
Plastic Insert
3. Replace the orifice
fittings into the valve.
4. Install the front panel
knobs
5. Before installing the regulator,
unscrew the octagonal cap, up you can
read (NAT) on the plastic insert out of
the cap, flip it over and snap back in
place. You can now read (L.P).
6. Continue with
installation.
Regulator with brass cap
L.P Position of insert