CPI ARAGON User Manual

General overview of the workshop manual's structure and purpose.

Explanation of symbols indicating warnings and safety precautions within the manual.

Details vehicle identification number (VIN) and engine number formats and locations.

General procedures for preparing tools, parts, and maintenance steps.

Lists detailed technical specifications for the Aragon GP 45 km/h model.

Provides a table of torque specifications for various fasteners and components.

Details electrical system specifications including voltages, currents, and bulb types.

Lists detailed technical specifications for the Aragon 45 km/h model.

List of special tools and their intended applications in maintenance.

Illustration of carburetor components and their assembly.

Important precautions and conditions before performing carburetor maintenance.

Diagnostic guide for common starting and mixture-related carburetor problems.

Step-by-step instructions for removing the carburetor from the vehicle.

Instructions for dismantling the carburetor, including jet and float chamber.

Procedure for measuring and setting the float chamber level.

Explains retaining clip's influence on A/F mixture and its adjustment.

Procedure to reset the carburetor to its factory default settings.

Instructions for removing, checking, and installing the reed-type inlet valve.

Exploded view of oil pump components and system layout.

Detailed steps for removing the oil pump from the engine.

Guidelines for checking oil pump for leaks, wear, and damage.

Instructions for bleeding oil pump and delivery lines after reinstallation.

Exploded view of crank drive, crankcase, and crankshaft assembly.

Steps for removing the cylinder head and related components.

Procedures for removing the piston, piston pin, and needle bearing.

Exploded views of crankcase and crankshaft components.

Instructions for mounting crankshaft bearings and crankshaft into crankcase.

Illustration of variomatic transmission system components.

Instructions for removing engine case cover and belt-drive components.

Guidelines for checking V-belt for wear, damage, and measuring width.

Procedures for checking roller weights for wear, damage, and roundness.

Steps for safely disassembling the clutch unit using specialized tools.

General instructions for reassembling clutch and transmission components.

Step-by-step guide for removing the generator assembly.

Instructions for measuring starter battery voltage and charging voltage.

Procedures for measuring ignition coil primary and secondary resistance.

Details on checking and adjusting engine ignition timing.

Instructions for measuring fuel level sensor resistance at different float positions.

Wiring connections for headlight dimmer switch positions.

Complete wiring diagram for the vehicle's electrical system.