Craftmade Teana - Fan Wiring; Wiring - Wall Control

page 7
7. Wiring.
(wiring for fan)
wire
connector
*
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wires from fan to
BLACK wire from ceiling. Connect WHITE wire
from fan to WHITE wire from ceiling. Connect all
GROUND (GREEN) wires together from fan to
BARE/GREEN wire from ceiling. Use wire
connectors provided when making connections.
If you intend to control the fan light with a
separate light switch connect BLUE wire from fan
to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
white
black supply wire
white supply wire
ground
(green or bare)
ground
(green
or bare)
from fan
black
white
blue
black
from ceiling
8. Wiring - Wall Control
Remove existing wall switch. Wire the wall control as
shown in diagram at right.
Connect BLACK/WHITE wire from wall control to
BLACK (AC IN L) wire in outlet box. Connect BLACK
wire from wall control to BLACK (AC IN N) wire from
fan (inside the outlet box). Connect BLUE wire from
wall control to BLUE wire from light in the outlet
box. Connect GREEN/YELLOW ground wire from
wall control to ground wire in the outlet box. Use
wire connectors provided when making
connections.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate
(included) to wall control using 2 screws provided
with the wall control.
plate
wall control
plate
screw
outlet box
BLACK
(AC IN N
from fan)
BLACK
BLUE
GREEN/
YELLOW
BLACK
(AC IN L)
BLACK/WHITE
green/
bare
ground
BLUE
(wiring for wall control)