Need help?Do you have a question about the Craftsman 103.23880 and is the answer not in the manual?
General| Swing Over Bed | 12 inches |
|---|---|
| Distance Between Centers | 36 inches |
| Motor Power | 1/2 HP |
| Tailstock Taper | MT2 |
| Spindle bore | 0.75 inches |
| Spindle Thread | 1 inch x 8 TPI |
| Weight | 250 lbs |
Adjusts distance between centers by loosening the lock to move the tailstock along the bed.
Makes minor adjustments to distance between centers by moving the cup center.
Holds the ram in a fixed position to prevent loosening due to vibration.
Loosens to change tool rest holder angle or position on the bed.
Secures the adjustable tool rest for any turning operation.
Locks the spindle assembly for layout or spacing operations.
Used for rough cutting and finishing irregular shapes; use with beveled edge down.
Used in a scraping manner to feed directly into the workpiece.
Recommended for cutting coves in cylindrical work, used in scraping manner.
Used for square cuts, sizing, shoulder cuts, and cutting off finished work.
Used for finishing cuts on cylinder work and cutting clearance.
Details on preparing, mounting, and securing work between centers.
Avoid loose clothing, double-check mounting, spin by hand, use tool rest, keep chisels sharp.
Always turn the workpiece by hand before applying power to ensure secure mounting.
Details on attaching work to face plate or backing plate for flat surface turning.
To Next Page
