Assembly (continued)
Insert Hose
Insert the hose locking end of the "Pos-I-
Lock®" hose into the inlet of the Vac. The
hose should snap into place. To remove
the hose from the Vac, press the release
button in the hose assembly and pull the
hose out of the Vac inlet, as shown.
Release Press
and
Button Pull
Accessory Storage
Your accessories may be stored in the
caster feet or in the storage locations on
the lid. The hose may be stored by
wrapping it around the unit and plugging
he open end into one of the storage
locations on the caster feet.
j Hose
Power
Push Button
End Of Hose
To Next Page
Loading...
