13
\
3
18
5
16
11B
6
11A
15
4
12B
1. WHEEL GUARD - Covers the grinding wheels and
protects against accidental contact.
2. WHEEL COVER - Covers the grinding wheels and
provides access for routine maintenance.
3. MOTOR HOUSING - Contains the electrical motor.
4. MOUNTING FEET- Helps to minimize vibration of
the grinder.
5. EYE SHIELD MOUNTS- Supports the eyeshields.
6. EYE SHIELDS- Protective Lexan see-thru shields to
prevent any loose debris from contacting the operator.
7. FLEXIBLE WORK LIGHT - Provides assistance to
the operator for grinding operations.
8. SPARK ARRESTORS - Prevents hot sparks and
debris from contacting the operator.
9. TOOL REST ADJUSTABLE SUPPORTS- Lets the
operator position the tool rest closer to the wheel as
the wheel decreases in diameter due to wear.
10. TOOL RESTS - Used to support the workpiece that is
being ground. Adjustable to provide angled surfaces.
11. A) 6" GRINDING WHEEL 60 GRIT - Used to
remove heavy material from workpiece.
9
A
11. B) 6" WIRE WHEEL - Used to remove light material
from workpiece.
12. A) ON / OFF SWITCH - Used to turn "ON" and turn
"OFF" the grinder.
12. B) VARIABLE SPEED SWITCH - Permits adjusting
rotational speed of grinding wheels.
13. WHEEL DRESSER- Used to clean and smooth
surface of the 6" Grinding Wheel only. Not to be
used with the 6" Wire Wheel.
14. QUENCH TRAY - Used to cool workpiece after
grinding.
15. MOUNTING PAD - Used to secure the grinder to a
workbench or suitable work surface.
16. GRINDING WHEEL IDENTIFICATION LABEL -
Provides information on wheel size, grit and
maximum rpm. Must be left on to distribute the load
of tightening the Lock Nuts.
17. FLANGES - Used to secure the grinding wheels to
the grinder and distribute the load of the Lock Nuts.
18. LOCK NUT - Used to secure the grinding wheels to
the grinder.
19. SPACER - Used to align the wire wheel into the
center of the Left Tool Rest.
To Next Page