Craftsman 152.22018 User Manual (English)

Questions and Answers:

O
omorenoJul 30, 2025
What to do if my Craftsman Grinder fuse blows or circuit breaker trips?
- J
  John BrownJul 30, 2025
  If the fuse blows or the circuit breaker trips on your Craftsman Grinder, it could be due to several reasons. First, try reducing pressure on the workpiece to avoid motor overload. Second, lessen the amount of items on the circuit to prevent an overloaded electrical circuit. Third, ensure you are using the correct fuse or circuit breaker, and replace it if necessary. Fourth, use the correct size of extension cord. Lastly, unplug the machine and remove any obstructions if the grinding wheels are blocked.
M
Mark ThompsonAug 4, 2025
How to troubleshoot a Craftsman Grinder motor that does not run?
- T
  Trevor HughesAug 4, 2025
  If the motor of your Craftsman Grinder isn't running, start by checking if the machine is properly plugged into the electrical receptacle. Next, verify that the power switch is in the “ON” position. If these steps don't solve the issue, the power cord may be faulty or the fuse or circuit breaker may be open due to an overloaded electrical circuit. In these cases, consider returning to Sears Service Center.
J
Jesse RamosAug 11, 2025
Why does my Craftsman 152.22018 motor run hot?
- M
  Michael HallAug 11, 2025
  If your Craftsman Grinder's motor is running hot, it could be due to the motor being overloaded; try reducing pressure on the workpiece. Another possible cause is poor air circulation around the motor; remove any blockage to improve air flow.
J
Judy PadillaAug 16, 2025
What to do if Craftsman 152.22018 Grinder motor stalls or runs slow?
- A
  Ann ParkerAug 16, 2025
  If your Craftsman Grinder motor stalls or runs slowly, it might be overloaded, so reduce pressure on the workpiece. Another cause could be incorrect line voltage, which a qualified electrician should check. If neither of these resolves the issue, the capacitor may have failed, and you should return to Sears Service Center.
M
Melissa VillaAug 23, 2025
Why Craftsman 152.22018 Grinder motor does not have full power?
- S
  Steve WileyAug 23, 2025
  If your Craftsman Grinder motor lacks full power, the issue might stem from incorrect line voltage, which requires a qualified electrician to check. Alternatively, the motor could be damaged, in which case you should return to Sears Service Center.