To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 875.199510 and is the answer not in the manual?
General| Type | Angle Grinder |
|---|---|
| Voltage | 120V |
| Power Source | Corded Electric |
| No Load Speed | 11, 000 RPM |
| Wheel Diameter | 4.5 inches |
| Wheel Thickness | 1/4 inch |
| Arbor Size | 5/8 inch |
Familiarize yourself with all instructions and warnings before operating any pneumatic tool.
Always wear impact-resistant eye protection meeting ANSI Z87.1 standards.
Use hearing protection when noise levels equal or exceed an 8-hour average of 85dBA.
Discontinue use if experiencing tingling, numbness, or pain from prolonged vibration.
Tool operates at a maximum of 90 PSI. Higher pressure can cause injury or tool failure.
Use accessories with RPM ratings meeting or exceeding the tool's RPM rating.
Some dust from activities contains chemicals known to cause cancer or birth defects.
Full one-year warranty on Craftsman air-drive tools for satisfaction.
Built-in regulator, lock-off lever throttle, and 360-degree rear exhaust.
Details collet size, free speed, weight, air consumption, hose size, and air inlet.
Clear air hose, shut off air line before changing accessories.
Connect tool to air supply using appropriate hose size and fittings.
Steps to safely disconnect, loosen collet, insert stone, and tighten collet nut.
Use in-line lubricator for tool life and sustained operation; check and fill regularly.
Addresses causes like grit, lack of oil, low pressure, leaks, worn parts.
Recommends draining the air compressor tank and lubricating the tool.
Troubleshoots lack of lubrication, incorrect regulator settings, or worn mechanisms.
Identifies worn impact mechanism components as the likely cause.
Points to a broken impact mechanism requiring component replacement.
