EasyManua.ls Logo

Craftsman 247.377051 - User Manual

Craftsman 247.377051
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Sears Brands Management Corporation, Hoffman Estates, IL 60179, U.S.A.
Visit our website: www.craftsman.com
CAUTION: Before using this product,
read this manual and follow all safety
rules and operating instructions.
Operators Manual
SAFETY
UNPACKING P. 8
ASSEMBLY
OPERATION
MAINTENANCE
ESPAÑOL
21” LAWN MOWER
Model No. 247.377051
Form No. 769-12122
(January 6, 2017)

Questions and Answers

  • D
    Denise MendozaSep 10, 2025
    Why does my Craftsman 247.377051 have excessive vibration?
    • L
      Lauren AlvarezSep 10, 2025
      If your Craftsman Lawn Mower is experiencing excessive vibration, the cutting blade might be loose or unbalanced; tighten the blade and adapter and balance the blade. Alternatively, the cutting blade could be bent, in which case you should replace it.
  • J
    Jason HoweAug 23, 2025
    How to fix uneven cut with Craftsman 247.377051?
    • R
      Robert ChristensenAug 23, 2025
      If your Craftsman Lawn Mower is providing an uneven cut, first ensure that the wheels are positioned correctly by adjusting the cutting height lever on the right front and right rear wheels to the same position. Also, check the blade; a dull blade can cause an uneven cut, so sharpen or replace it.
  • M
    Melanie PatrickAug 25, 2025
    Why Craftsman Lawn Mower engine fails to start?
    • R
      Rachel JonesAug 25, 2025
      The Craftsman Lawn Mower engine may fail to start due to several reasons: - The blade control might be disengaged, so ensure it is engaged. - The spark plug boot could be disconnected; check and connect it. - The fuel tank may be empty or contain stale fuel; refill with fresh gasoline. - The engine may not be primed; prime it as instructed in the Operation section. - The spark plug might be faulty; clean, adjust the gap, or replace it. - The engine could be flooded; wait a few minutes before restarting.
  • J
    jrodriguezAug 26, 2025
    What to do if Craftsman Lawn Mower engine fails to start with electric starter?
    • K
      Kathryn MeltonAug 26, 2025
      If your Craftsman Lawn Mower engine fails to start with the electric starter, consider the following: - Ensure the Electric Starter Push Key is fully inserted into the starter housing until it snaps into place. - The battery may not be charged. Charge the battery. - The circuit breaker might have tripped. Stop the engine, remove the Electric Starter Push Key, and disconnect the spark plug boot. Check for and carefully remove any debris obstructing the blade. Reattach the spark plug boot and reinsert the Electric Starter Push Key. Wait one minute for the circuit breaker to automatically reset, then try starting again.
  • G
    Gina FordAug 28, 2025
    What to do if Craftsman 247.377051 Lawn Mower will not self propel?
    • A
      alexis40Aug 28, 2025
      If your Craftsman Lawn Mower will not self-propel, check that the belt is installed properly, ensuring correct pulley installation and movement. Also, remove any debris clogging the drive operation by stopping the engine, disconnecting the spark plug boot, and cleaning out the debris. If the belt is damaged or worn, contact a service center to have it replaced.
  • D
    durhamterriAug 29, 2025
    What to do if Craftsman Lawn Mower engine runs erratic?
    • S
      susanjohnsonAug 29, 2025
      If your Craftsman Lawn Mower engine runs erratically, it could be due to: - A loose spark plug boot. Connect and tighten the spark plug boot. - Stale fuel. Replace the fuel with clean, fresh gasoline. - A plugged vent in the gas cap. Clear the vent. - Water or dirt in the fuel system. Run the engine until it stops due to lack of fuel, then refill with fresh fuel. - A dirty air cleaner. Refer to the Air Cleaner Maintenance section in the Engine Manual.
  • E
    Edward BoydSep 18, 2025
    Why Craftsman 247.377051 occasionally skips?
    • J
      jeremy92Sep 18, 2025
      Occasional skipping or hesitation in your Craftsman Lawn Mower may be due to: - The spark plug gap being too close. Adjust the gap, referring to the Spark Plug Maintenance section in the Engine Manual.
  • J
    Jason ReeseSep 12, 2025
    Why does my Craftsman 247.377051 idle poorly?
    • D
      davidclarkSep 12, 2025
      If your Craftsman Lawn Mower is idling poorly, reset the gap or replace the spark plug if it is fouled, faulty, or the gap is too wide.
  • C
    Curtis SpenceSep 8, 2025
    Why is my Craftsman 247.377051 engine overheating?
    • M
      miranda16Sep 8, 2025
      If your Craftsman Lawn Mower engine is overheating, check the engine oil level and fill the crankcase with the proper oil if it's low. Also, ensure that there is no restriction to air flow around the engine by cleaning the area around and on top of the engine.
  • P
    Paul MartinezSep 5, 2025
    Why is my Craftsman Lawn Mower engine running erratic?
    • A
      Amy NicholsSep 5, 2025
      If your Craftsman Lawn Mower engine is running erratically, there are several potential causes. A loose spark plug boot can be the culprit; connect and tighten it. Stale fuel can also cause this issue, so replace it with clean, fresh gasoline. Check the vent in the gas cap; if it's plugged, clear it. Water or dirt in the fuel system can also lead to erratic engine performance; run the engine until it stops from lack of fuel, then refill with fresh fuel. If the fuel line is blocked, contact a service center to have it cleaned.

Summary

Safety Instructions

General Operation Safety

Read and follow all instructions and safety practices before operating the machine.

California Proposition 65

Information regarding chemicals known to the State of California to cause cancer and birth defects.

Safety Instructions

Slope Operation Safety

Guidelines for safely operating the mower on slopes, including maximum angle.

Child Safety Precautions

Safety precautions regarding children near the operating mower.

Service Safety

Safety precautions for handling gasoline and general service procedures.

Safety Instructions

General Service Safety

Safety advice for maintenance, cleaning, and general servicing of the mower.

Engine Modification Warning

Warning against modifying the engine, which can cause unsafe speeds and injury.

Emissions Notice

Information on emission control systems and compliance with regulations.

Spark Arrestor Requirement

Requirement for spark arrestors on engines used in certain land conditions.

Safety Instructions

Safety Symbols Explanation

Explanation and description of safety symbols used on the product and in the manual.

Slope Gauge

Assembly

Opening Carton

Instructions for opening the product's shipping carton and removing it.

Removing Unit from Carton

Steps to safely remove the lawn mower unit from its packaging.

Attaching the Handle

Detailed steps for assembling and attaching the mower's handle.

Assembly

Attaching the Grass Catcher

Instructions for assembling and attaching the grass catcher to the mower.

Assembly

Attaching Side Discharge Cover

Steps to attach the side discharge cover for alternative grass clipping management.

Adjustments

Procedures for adjusting cutting height and handle pitch for operation.

Operation

Operating Controls and Components

Identification and function of key controls and components like Blade Control, Drive Control, and Recoil Starter.

Operation

Starting the Engine

Step-by-step instructions for starting the lawn mower engine.

Stopping the Engine

Procedure for safely stopping the lawn mower engine.

Using Your Lawn Mower

Guidance on using the mower as a mulcher or with a grass catcher.

Service and Maintenance

Maintenance Schedule

A schedule outlining recommended maintenance tasks and intervals for the mower.

General Maintenance Recommendations

General advice and safety rules for performing maintenance on the mower.

Lubrication Guide

Lubrication points and frequency for mower components.

Blade Control Lubrication

Lubrication instructions for the blade and drive controls.

Service and Maintenance

Engine Care Instructions

Instructions for cleaning and maintaining the engine.

Mower Cleaning and Maintenance

Procedures for cleaning the mower deck and general upkeep.

Blade Care Procedures

Procedures for sharpening, balancing, and replacing the mower blade.

Belt Care Information

Information regarding the mower's drive belt and its maintenance.

Off-Season Storage

Preparing the Engine for Storage

Instructions for preparing the engine for long-term storage.

Preparing the Lawn Mower for Storage

Steps for cleaning and preparing the mower for storage.

Battery Care During Storage

Care instructions for the mower's battery during storage.

Troubleshooting

Troubleshooting

Notes

Emission Control System Warranty Statement

Repair Protection Agreement

Craftsman 247.377051 Specifications

General IconGeneral
BrandCraftsman
Model247.377051
CategoryLawn Mower
LanguageEnglish

Related product manuals