EasyManua.ls Logo

Craftsman 247.888301 - User Manual

Craftsman 247.888301
76 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Sears Brands Management Corporation, Hoffman Estates, IL 60179, U.S.A.
Visit our website: www.craftsman.com
CAUTION: Before using
this product, read this
manual and follow all
safety rules and operating
instructions.
Operator’s Manual
30” SNOW THROWER
Model No. 247.888301
• SAFETY
• ASSEMBLY
• OPERATION
• MAINTENANCE
• PARTS LIST
• ESPAÑOL
7/26/2011
FORM NO. 769-05137E

Table of Contents

Questions and Answers

  • S
    Shawna BakerAug 7, 2025
    Why won't my Craftsman 247.888301 engine start?
    • J
      Joseph MossAug 8, 2025
      Several factors can prevent your Craftsman Snow Blower engine from starting. Here's what to check: * Ensure the choke control is in the CHOKE position; if not, move it accordingly. * Verify the spark plug wire is connected to the spark plug; connect if disconnected. * Inspect the spark plug for faults; clean, adjust the gap, or replace it if necessary. * Make sure the fuel tank isn't empty and that you're using clean, fresh gasoline. * Prime the engine as instructed in the Operation Section. * Ensure the key is fully inserted into the switch. * If equipped with an electric start, confirm the extension cord is properly connected to both the snow blower and a grounded AC outlet.
  • U
    uwilliamsAug 12, 2025
    Why is my Craftsman Snow Blower engine running erratically?
    • N
      Nathaniel GreerAug 12, 2025
      Erratic engine performance in your Craftsman Snow Blower can stem from a few causes: * The engine might be running on CHOKE; move the choke control to the RUN position. * The fuel could be stale; replace it with clean, fresh gasoline. * There might be water or dirt in the fuel system; drain the fuel tank by running the engine until it stops, then refill with fresh fuel. * The engine might be over-governed. In this case, contact your Sears Parts & Repair Center.
  • J
    Jason MeadowsAug 16, 2025
    What to do if my Craftsman 247.888301 loses power?
    • R
      Richard KellyAug 16, 2025
      If your Craftsman Snow Blower is experiencing a loss of power, check these items: * Ensure the spark plug wire is securely connected and tightened. * Inspect the gas cap vent hole for blockages from ice or snow, and clear it to ensure proper ventilation.
  • J
    Jerry AndersonAug 20, 2025
    What to do if my Craftsman 247.888301 Snow Blower unit fails to discharge snow?
    • L
      Lindsay CollierAug 20, 2025
      If your Craftsman Snow Blower isn't discharging snow, here's what you should do: 1. Immediately stop the engine and disconnect the spark plug wire. 2. Check the chute assembly for clogs and clean it, along with the inside of the auger housing, using a clean-out tool or stick. 3. Inspect the auger for any foreign objects and remove them using a clean-out tool or stick. 4. If the auger cable needs adjustment, refer to the Assembly section for instructions. 5. For a loose or damaged auger belt, replacement instructions can be found in the Service and Maintenance section. 6. Replace any sheared shear pins with new ones.
  • J
    Jonathan ReevesAug 25, 2025
    What to do if my Craftsman 247.888301 has excessive vibration?
    • J
      james18Aug 26, 2025
      If your Craftsman Snow Blower is vibrating excessively: Stop the engine immediately, and disconnect the spark plug wire. Then, tighten all bolts and nuts. If the vibration continues after this, have the unit serviced by a Sears Parts & Repair Center.
  • B
    brucewandaAug 29, 2025
    What to do if my Craftsman 247.888301 Snow Blower unit fails to propel itself?
    • J
      Jennifer KempAug 29, 2025
      If your Craftsman Snow Blower isn't moving on its own, there are several potential reasons: * The drive cable may need adjustment; consult the Service and Maintenance section for instructions. * The drive belt could be loose or damaged; replacement instructions are in the Service and Maintenance section. * The friction wheel might be worn; consider changing it or contacting your Sears Parts & Repair Center.
  • A
    Alexandria ScottSep 2, 2025
    How to fix a Craftsman 247.888301 chute that won't rotate?
    • S
      Steve HamiltonSep 2, 2025
      If the chute on your Craftsman Snow Blower doesn't easily rotate, it might be assembled incorrectly. Disassemble the chute control and reassemble it as directed in the Assembly section.

Craftsman 247.888301 Specifications

General IconGeneral
BrandCraftsman
Model247.888301
CategorySnow Blower
LanguageEnglish

Related product manuals