6
_For best results mower blades must be kept sharp. Replace
bent or damaged blades,
BLADE REMOVAL
Raise mower to highest position to allow access to blades.
Remove hex bolt, lock washer and flat washer securing
b_ade.
Install new or resharpened blade with trailing edge up
towards deck as shown.
Impo_ant: To ensure proper assembly, center hole in blade
must align with star on mandrel assembly.
Reassemble hex bolt, lock washer and flat washer in exact
order as shown.
Tighten bolt securely (27:35 Ft, Lbs. torque).
IMPORTANT: Blade bolt is grade 8 heat treated
68
To Next Page
