Craftsman 316.29262 - User Manual

Questions and Answers

O
oandersonAug 11, 2025
Why my Craftsman 316.29262 Tiller engine will not start?
- H
  Heather WilliamsAug 11, 2025
  If your Craftsman Tiller engine won't start, several factors could be the cause. First, ensure the fuel tank isn't empty; if it is, refill it with fresh fuel. If the engine is flooded, squeeze the trigger and pull the starter rope. Also, old fuel could be the culprit, so drain the tank and add fresh fuel. Other potential issues include a fouled spark plug (replace it), a plugged spark arrestor (clean or replace it), or the outside temperature being too low (below 40º F, pull the starter rope 10-15 times) or too high (above 90º F, squeeze the throttle control and pull the starter rope). Finally, make sure you have pressed the primer bulb fully and slowly 10 times.
H
hunterisaiahAug 17, 2025
What to do if Craftsman 316.29262 Tiller engine will not idle?
- A
  Alex RichardsonAug 17, 2025
  If your Craftsman Tiller engine won't idle, it could be due to a few reasons. The air filter might be plugged, so replace or clean it. Old fuel can also cause this issue, so drain the gas tank and add fresh fuel. For an improper carburetor adjustment, adjust according to the Carburetor Adjustments section.
J
jhinesAug 26, 2025
What to do if Craftsman 316.29262 Tiller engine lacks power or stalls when under load?
- D
  Dustin HarrisonAug 26, 2025
  If your Craftsman Tiller engine lacks power or stalls when under load, consider these possible causes: old fuel (drain the gas tank and add fresh fuel), a fouled spark plug (replace the spark plug), a plugged spark arrestor (clean or replace the spark arrestor). It may also be due to cultivator tines bound with debris; in this case, stop the unit, switch the On/Off Stop Control to STOP, and clean and remove any debris binding the tines. For an improper carburetor adjustment, take your tiller to a Sears Parts & Repair center or other qualified service dealer for an adjustment.
K
Kelly WoodsSep 1, 2025
How to fix a Craftsman Tiller engine that will not accelerate?
- K
  Katie RichardsonSep 2, 2025
  If your Craftsman Tiller engine will not accelerate, there are several possible reasons. Old fuel could be the problem; drain the gas tank and add fresh fuel. A dirty air filter can also cause this issue, so clean or replace the air filter. Additionally, a plugged spark arrestor might be the cause; clean or replace it. For an improper carburetor adjustment, take your tiller to a Sears Parts & Repair center or other qualified service dealer for an adjustment.

Summary

Introduction and Warranty

Warranty Coverage and Safety Warnings

Rules for Safe Operation

Safety Symbols and General Precautions

Explains safety symbols, importance of reading the manual, and general operating precautions.

Specific Operational Safety Guidelines

Provides critical safety instructions for operating the unit, including personal protection and area preparation.

Oil and Fuel Information

Fuel Mixing, Handling, and Filling

Starting and Stopping Instructions

Engine Starting Procedure

Step-by-step guide on how to start the mini-tiller engine, including choke and primer usage.

Engine Stopping Procedure

Procedures for safely shutting down the mini-tiller engine.

Operating Instructions

Safe Operation Tips and Transport

Maintenance and Repair Instructions

Troubleshooting

Common Engine Problems and Solutions

Provides solutions for common problems like engine not starting, idling, or accelerating.

Parts List

Craftsman 316.29262 Specifications

General

Model Number	316.29262
Engine Type	4-Cycle
Tilling Depth	Up to 8 inches
Manufacturer	Craftsman
Tine Direction	Forward rotating
Number of Tines	4
Wheel Size	8 inches
Fuel Type	Gasoline