Craftsman 580.672200 - User Manual

Questions and Answers

T
tannermartinezJul 31, 2025
Why is my Craftsman 580.672200 pump not building pressure?
- C
  Carol CareyJul 31, 2025
  If the Craftsman Pressure Washer pump fails to produce pressure, exhibits erratic pressure, chatters, loses pressure, or has low water volume, there are several potential causes. First, ensure the nozzle is in high pressure mode by pulling it backward. Check for and clear any blockages in the water inlet or high pressure hose. Make sure the water supply is adequate and not exceeding 100°F. Straighten any kinks or patch leaks in the inlet hose. Inspect and clean the inlet hose strainer and the nozzle. If the gun leaks, it may need replacement. If none of these steps resolve the issue, the pump may be faulty, and it is recommended to contact a Sears service facility.
E
Edward MooreAug 5, 2025
What to do if Craftsman Pressure Washer engine will not start?
- E
  Erica LoveAug 5, 2025
  If your Craftsman Pressure Washer engine won't start or runs rough, several factors could be at play. Start by checking the air cleaner and clean or replace it if dirty. Ensure the fuel tank has fuel and that the fuel is fresh; drain and refill if stale or contaminated with water. Verify the spark plug wire is securely connected to the spark plug, and replace the spark plug if it's bad. For issues like an excessively rich fuel mixture, a stuck intake valve, or loss of engine compression, contact a Sears service facility.
S
susan57Aug 12, 2025
Why does my Craftsman Pressure Washer engine shut down?
- C
  Christopher ThompsonAug 12, 2025
  If the Craftsman Pressure Washer engine shuts down during operation, the most likely cause is running out of fuel. Simply fill the fuel tank to resume operation.
K
Kenneth GatesAug 17, 2025
How to fix detergent not mixing in Craftsman 580.672200 Pressure Washer?
- M
  Michael MillerAug 17, 2025
  If the detergent isn't mixing with the spray on your Craftsman Pressure Washer, first ensure the detergent siphoning tube is fully submerged in the detergent. Next, check the chemical filter for clogs and clean or replace it if necessary. Also, make sure the nozzle is in the low pressure mode by pushing it forward. For a dirty in-line filter, refer to the section on "Check In-Line Filter".
J
Jeanette CalderonAug 23, 2025
What to do if Craftsman 580.672200 Pressure Washer bogs down under load?
- N
  Nathan ChenAug 25, 2025
  If the Craftsman Pressure Washer engine runs well without a load but bogs down when a load is added, the engine speed may be too slow. Try moving the throttle control to the FAST position. If the engine continues to bog down, it is recommended to contact a Sears service facility.