EasyManua.ls Logo

Craftsman 580.752800 - User Manual

Craftsman 580.752800
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Owner's Manual
ICRRFTSHRN°I
7.0 HORSEPOWER
2800 PSI
2.5 GPM
PRESSURE WASHER
CLEANING SYSTEM
Model No. 580.752800
HOURS: Mon. - FrL 8 a.m. to 5 p.m. (CT)
CAUTION: Before using this product,
read this manual and follow all Safety
Rules and Operating Instructions,
SEARS, ROEBUCK and CO,, Hoffman Estates, IL 60179 U,S,A,
Visit our Craftsman website: www.sears.com/craftsman
Past No. 194126GS Dral) i (02/17/2004)
• Safety
• Assembly
• Operation
• Maintenance
• Parts
• Espafiol

Table of Contents

Questions and Answers

  • K
    Kyle ClarkJul 31, 2025
    Why does my Craftsman 580.752800 engine not start or run rough?
    • J
      James ReyesJul 31, 2025
      There are several reasons why your Craftsman Pressure Washer engine might not start or runs rough: * The air cleaner might be dirty, so you should clean or replace it. * You might be out of or have stale gasoline, so fill the fuel tank or drain it and fill with fresh fuel. * The spark plug wire might not be connected, so connect it to the spark plug. * The spark plug might be bad, so replace it. * There might be water in the gasoline, so drain the gas tank and fill it with fresh fuel. * You might be overchoking, so open the choke fully and crank the engine.
  • S
    Scott JordanAug 7, 2025
    What to do if Craftsman 580.752800 Pressure Washer fails to produce pressure?
    • J
      jonathan92Aug 7, 2025
      If your Craftsman Pressure Washer isn't producing pressure, here are some things to check: * Ensure you're using a high-pressure spray tip instead of a low-pressure one. Replace the spray tip if needed. * Check for and clear any blockages in the water inlet. * Make sure you have an adequate water supply. * Inspect the inlet hose for kinks or leaks; straighten or patch as necessary. * Examine the inlet hose strainer for clogs and clean it. * Ensure your water supply isn't exceeding 100°F; use a cooler water source. * Look for blockages or leaks in the high-pressure hose; clear any blockages or replace the hose if needed. * Check the spray tip for obstructions and clean it.
  • N
    Nicole TorresAug 15, 2025
    Why doesn't detergent mix with spray in my Craftsman 580.752800?
    • P
      Patricia HayesAug 15, 2025
      If the detergent isn't mixing with the spray in your Craftsman Pressure Washer, consider the following: * Check the detergent line for collapses or kinks; repair or replace it if necessary. * If the chemical tank filter is clogged, replace the tank. * Replace spray tip with low pressure spray tip. * Ensure the Dial-a-Cleaner™ knob isn't in the off position; rotate it to the desired chemical setting.
  • J
    joseph59Aug 23, 2025
    What to do if choke is opened too soon on Craftsman Pressure Washer?
    • L
      Lynn ShawAug 23, 2025
      Move choke to halfway position until engine runs smoothly.

Summary

WARRANTY

Hazard Symbols and Meanings

Explains various hazard symbols and their meanings for safety.

KNOW YOUR PRESSURE WASHER

ASSEMBLY

Remove Pressure Washer From Carton

Carton Contents Check

Attach Handle Assembly

Assemble Cleaning System

Outlines the steps to assemble the cleaning system before operation.

Add Engine Oil

Details how to add the correct type and amount of engine oil.

Add Fuel to Tank

Guide for safely filling the fuel tank with unleaded gasoline.

Connect Hose and Water Supply

Steps for connecting the garden hose and high pressure hose.

Checklist Before Starting Engine

A final check of all connections and fluids before engine start.

OPERATION

How to Use Your Cleaning System

Starting Your Cleaning System

Step-by-step instructions for starting the engine and system.

Stopping Your Cleaning System

Procedures for safely shutting down the pressure washer.

How to Use Spray Tips

Cleaning and Applying Chemical

Wash and Rinse Surface

Rinse System After Every Use

Automatic Cool Down System

MAINTENANCE

Owners Responsibilities

Maintenance Schedule

A chart detailing required maintenance tasks and intervals.

General Maintenance Recommendations

Before Each Use Checks

Essential checks to perform before starting the pressure washer.

Pressure Washer Maintenance Procedures

Specific maintenance tasks for the pressure washer components.

Purge Pump of Air and Contaminants

Nozzle Maintenance and Cleaning

Pump Oil Change

Instructions for draining and refilling the pump oil.

Engine Oil Level Check

How to check and maintain the correct engine oil level.

Engine Oil Change Procedure

Steps for changing the engine oil after initial use and regular intervals.

Service Air Cleaner

Instructions for cleaning or replacing the air cleaner element.

Service Spark Plug

Guidance on inspecting, cleaning, and replacing the spark plug.

STORAGE

After Each Use Storage Procedures

Steps to take after every use to prepare the unit for storage.

Winter Storage Instructions

Specific procedures to protect the unit from freezing during winter.

Long Term Storage Preparation

How to prepare the engine and fuel system for storage over 30 days.

Protect Fuel System for Storage

Methods to prevent fuel system gumming and damage during storage.

Engine Oil Change for Storage

Oil Cylinder Bore

Protect Pump with Saver

Instructions for using pump saver to prevent freeze damage and lubricate seals.

Other Storage Guidelines

TROUBLESHOOTING

Pump Performance Issues

Addresses problems like low pressure, chattering, or low water volume.

Detergent Mixing Problems

Engine Bogging Under Load

Engine Starting and Running Problems

Solutions for when the engine won't start or runs roughly.

Engine Shutdown Issues

Engine Power Loss

Engine Hunting or Faltering

Emission Control System Warranty

Emission Control Warranty Statement

California and EPA Emission Control Warranty

Sears Emission Control Defects Coverage

Owners Warranty Responsibilities

Emission Control Warranty Provisions

Craftsman 580.752800 Specifications

General IconGeneral
Power SourceGasoline
Max Pressure2800 PSI
Flow Rate2.3 GPM
Hose Length25 feet
Engine Type4-Cycle OHV
Water Flow2.3 GPM
Pump TypeAxial Cam
Soap ApplicatorYes
Nozzle Types0°, 25°, 40°, Soap
Wheel TypePneumatic

Related product manuals