Craftsman 580.752870 - User Manual

Questions and Answers

V
vanessaedwardsAug 10, 2025
What to do if my Craftsman 580.752870 Pressure Washer engine will not start?
- L
  Lorraine AllenAug 10, 2025
  If your Craftsman Pressure Washer engine won't start, starts and runs rough, or shuts down during operation, consider these potential causes: * The engine rocker switch may be set to the OFF (0) position. Set it to the ON (I) position. * The oil level may be low. Fill the crankcase to the proper level. * The air cleaner may be dirty. Clean or replace the air cleaner. * The unit may be out of fuel. Fill the fuel tank. * The fuel may be stale. Drain the fuel tank and fill it with fresh fuel. * The spark plug wire may not be connected to the spark plug. Connect the wire to the spark plug. * The spark plug might be bad. Replace the spark plug. * There might be water in the fuel. Drain the fuel tank and fill it with fresh fuel.
R
rebecca85Aug 20, 2025
Why is my Craftsman 580.752870 not mixing detergent with the spray?
- A
  Angela MorrisAug 20, 2025
  If the detergent is not mixing with the spray in your Craftsman Pressure Washer, it could be due to the following reasons: * The detergent siphoning tube is not submerged. Insert the detergent siphoning tube into the detergent. * The detergent siphoning tube is clogged or cracked. Clean or replace the detergent siphoning tube. * A high-pressure spray tip is installed. Replace it with a low-pressure spray tip. * The detergent siphoning check ball is stuck. Free the detergent siphoning check ball.
J
James EnglishOct 29, 2025
Why is my Craftsman 580.752870 pump not building pressure?
- L
  Levi ReeseOct 30, 2025
  There are several reasons why your Craftsman Pressure Washer pump might fail to produce pressure, have erratic pressure, chatter, lose pressure, or have low water volume: * A low-pressure spray tip might be installed. Replace it with a high-pressure spray tip. * The water inlet could be blocked. Clear the inlet. * There might be an inadequate water supply. Provide adequate water flow. * The inlet hose could be kinked or leaking. Straighten the inlet hose or patch any leaks. * The inlet hose screen might be clogged. Check and clean the inlet hose screen. * The water supply might be over 100°F. Provide a cooler water supply. * The high-pressure hose might be blocked or leaking. Clear any blockages in the outlet hose. * The spray gun could be leaking. Replace the spray gun. *...