• Move Ignition Switch Lever to the ON position. = Return the starter grip handle slowly.
o
°
IGNITION SWITCH LEVER
Position the nozzle in the low pressure mode (nozzle
stid forward) and squeeze the trigger on the spray
gun to relieve the air pressure caused by turning ON
the water. Water witl flow out of the gun in a thin
stream. Continue to hold trigger until you have a
steady stream of water and no air remains in the
system. This will make it easier to pull start the
engine. Release the trigger.
Engage the safety latch on the spray gun.
Grasp the starter grip handle and pull slowly until you
feel some resistance. Then pull rapidly to start the
engine.
Starter Grip
TO STOP YOUR PRESSURE WASHER
, Move the ignitionSwitch Lever to the OFF position.
° Wait for the engine to idle down.
• Simply shutting off the engine will not release
pressure in the system. Squeeze trigger on the
spray gun to relieve pressure in the hose.
Note: A small amount of water will squirt out from the
spray gun when you release the pressure.
SIPHONING
We recommend that you DO NOT siphon standing water
for your water supply. Contaminated, brackish or dirty
water can damage the pump. Connect only to household
water supply.
TIPS
, Never use the garden hose inlet to siphon detergent
or wax.
° if you have the spray nozzle too far away, cleaning
will not be as effective.
10
To Next Page
Loading...
