Craftsman 580.767302 User Manual

Craftsman 580.767302

44 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

6.5 HORSEPOWER

2400 PSI

2.2 GPM

PRESSURE WASHER

PRESSURE WASHER

CUSTOMER HELPLINE

1-800-222-3136

Model No. 580.767302

CAUTION:

Before using this product,

read this manual and follow all Safety

Rules and Operating Instructions.

HOURS: Mon. - Fri. 8 a.m. to 5 p.m. (CT)

Part No. 190821GS Draft 2 (06/10/2002)

SEARS, ROEBUCK and CO., Hoffman Estates, IL 60179 U.S.A.

Visit our Craftsman website: www.sears.com/craftsman

Owner’s Manual

• Safety

• Assembly

• Operation

• Maintenance

• Parts

• Español

Questions and Answers:

M
Matthew MendezJul 29, 2025
Why does my Craftsman 580.767302 engine will not start or runs rough?
- B
  bgrimesJul 29, 2025
  Your Craftsman Pressure Washer might not start or run roughly due to several reasons: * The air cleaner might be dirty, so you should clean or replace it. * The gasoline tank may be empty, so you should fill it. * The gasoline may be stale, so you should drain the tank and fill it with fresh fuel. * The spark plug wire may not be connected, so you should connect it. * The spark plug may be bad, so you should replace it. * There may be water in the gasoline, so you should drain the tank and fill it with fresh fuel. * It may be overchoking, so you should open the choke fully and crank the engine.
B
Bruce DavisAug 3, 2025
What to do if my Craftsman Pressure Washer pump fails to produce pressure?
- K
  Kristen PerkinsAug 3, 2025
  If your Craftsman Pressure Washer pump fails to produce pressure, produces erratic pressure, chatters, loses pressure, or has low water volume, consider the following: * Ensure the nozzle is not in low pressure mode by pulling the nozzle backward for high pressure mode. * Check for and clear any blockage in the water inlet. * Ensure an adequate water supply. * Straighten any kinks or patch any leaks in the inlet hose. * Check and clean the inlet hose strainer. * Ensure the water supply is not over 100°F; provide a cooler water supply. * Clear any blockages or leaks in the high pressure hose. * Clean the nozzle if obstructed. * Replace the gun if it leaks.
F
frankbernardAug 6, 2025
What to do if Craftsman 580.767302 Pressure Washer engine shuts down during operation?
- J
  Jacob SmithAug 6, 2025
  If your Craftsman Pressure Washer engine shuts down during operation, the most likely cause is that the fuel tank is empty. Refill the fuel tank.
H
Heather AyalaAug 11, 2025
Why is my Craftsman Pressure Washer engine lacking power?
- E
  Eric MoranAug 11, 2025
  If your Craftsman Pressure Washer engine lacks power, the air filter is likely dirty. Replace the air filter.
D
David HarperAug 15, 2025
Why is detergent not mixing with spray in my Craftsman Pressure Washer?
- A
  Alex SimpsonAug 15, 2025
  If detergent fails to mix with the spray in your Craftsman Pressure Washer, consider the following: * Ensure the detergent siphoning tube is submerged in the detergent. * Clean or replace the chemical filter/detergent siphoning tube if it is clogged. * Ensure the nozzle is in low pressure mode by pushing the nozzle forward.
V
Victoria HessAug 19, 2025
What to do if Craftsman Pressure Washer engine runs good at no-load but bogs when load is added?
- J
  Jason CollinsAug 19, 2025
  If your Craftsman Pressure Washer engine runs well without a load but bogs down when a load is added, it may be due to slow engine speed. Move the throttle control to the FAST position.
F
Fernando KerrAug 25, 2025
Why does my Craftsman Pressure Washer engine hunts or falters?
- L
  lowekarenAug 25, 2025
  If your Craftsman Pressure Washer engine hunts or falters, it may be because the choke is opened too soon. Move the choke to the halfway position until the engine runs smoothly.

Craftsman 580.767302 Specifications

General

Power Source	Gasoline
Flow Rate	2.3 GPM
Hose Length	25 ft
Engine	Briggs & Stratton
Pump	Axial Cam
Nozzles Included	0°, 25°

Summary

Warranty

Limited Warranty on Craftsman Pressure Washer

Details the limited warranty terms for the pressure washer.

Safety Rules

General Safety Rules

Provides essential safety precautions and warnings for operating the pressure washer.

Assembly

Unpacking and Carton Contents

Steps to remove the pressure washer from its carton and check all included parts.

Initial Assembly Steps

Instructions for attaching the handle, hooks, and other initial components.

Hose Reel Assembly and Fluid Addition

Guidance on assembling the hose reel and adding engine oil and gasoline.

Connecting Hoses and Pre-Start Checklist

Steps to connect hoses, water supply, and perform pre-start checks.

Operation

Know Your Pressure Washer

Identifies key components and controls of the pressure washer for familiarization.

Starting and Stopping the Pressure Washer

Step-by-step guide on how to start and safely stop the pressure washer engine.

Adjusting Spray Nozzle and Applying Detergent

Instructions for adjusting the nozzle and using the detergent system.

Pressure Washer Rinsing and Hose Reel Use

Guidelines for rinsing and using the hose reel for storage.

Maintenance

Owner's Responsibilities and Schedule

Outlines owner duties and the maintenance schedule for the pressure washer.

Product Specifications and General Recommendations

Lists technical specs and general advice for maintaining the pressure washer.

Before Each Use Checks and Washer Maintenance

Essential checks before use and maintenance for washer components like inlet screen and hose.

O-Ring and Engine Maintenance

Procedures for maintaining O-rings and performing engine oil checks and changes.

Engine Service: Air Cleaner, Spark Plug, Carburetor, Spark Arrester

Maintenance tasks for the engine's air cleaner, spark plug, carburetor, and spark arrester.

Storage

After Each Use Procedures

Steps to follow after using the pressure washer to prepare it for storage.

Winter Storage Preparation

Instructions to protect the pressure washer from freezing temperatures during winter.

Long Term Storage Preparation

Procedures for preparing the engine and pump for storage exceeding 30 days.

Troubleshooting

Pump Performance Issues

Addresses problems like failure to produce pressure, erratic pressure, and low water volume.

Engine Starting and Operation Problems

Solutions for engine not starting, running rough, shutting down, or lacking power.

Parts

Main Unit Exploded View

Diagram showing the exploded view of the main unit components.

Main Unit Parts List

A detailed list of parts for the main unit with item numbers and descriptions.

Optional Accessories

Lists optional accessories available for the pressure washer.

Pump Exploded View

Diagram showing the exploded view of the pump components.

Pump Parts List

A detailed list of parts for the pump with item numbers and descriptions.

Engine

Engine Exploded View

Diagram illustrating the exploded view of the engine components.

Engine Gasket and Overhaul Kits

Details gasket sets and overhaul kits for the engine.

Engine Components Exploded Views

Diagrams showing exploded views of various engine components like air cleaner and starter.

Engine Parts List

A detailed list of engine parts with item numbers and descriptions.

Emission Control Warranty Statement

Warranty Rights, Coverage, and Responsibilities

Explains warranty rights, manufacturer coverage, and owner responsibilities.

What is Covered and Not Covered

Details which parts and failures are covered by the emission control warranty.

Filing a Claim and Warranty Service

Procedures for filing a warranty claim and locating authorized service centers.

Related product manuals

Craftsman 580.767300

Craftsman 580.767301

Preview: Craftsman 580.767700

Craftsman 580.767700

Preview: Craftsman 580.767450

Craftsman 580.767450

Craftsman 580.767201

Craftsman 580.767200

Preview: Craftsman 580.767202

Craftsman 580.767202

Preview: Craftsman 580.767100

Craftsman 580.767100

Craftsman 580.76201

Preview: Craftsman 580.761652

Craftsman 580.761652

Craftsman 580.768350

Preview: Craftsman 580.768330

Craftsman 580.768330